ASE A6 Test Prep (Electrical & Electronic Systems) UPDATED ACTUAL
Questions and CORRECT Answers
A technician connects one lead of a DMM (digital multimeter) to the positive (+)
terminal of a battery and the other meter lead to the "B" terminal of the starter
solenoid and then cranks the engine. During cranking, the voltmeter displays a
reading of 878 mV.
Technician A says this reading indicates the positive battery cable has very high
resistance.
Technician A only
Technician B says this reading indicates that the starter armature is defective.
Who is right?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
When performing a load test on a battery, a technician finds that the battery
voltage drops below specifications. Which of the following is the MOST likely
repair?
Replace the battery
a. Recharge the battery and return it to service
b. Recharge the battery and retest it
c. Replace the battery
d. Replace the voltage regulator
, Two technicians are describing battery charging.
Technician A says to remove the surface charge from a recently charged battery and
apply a 300-ampere load across the adapters for 15 seconds.
Technician B says to remove the surface charge from batteries, which have been in
storage.
Technician A only
Who is right?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
A technician connects one lead of a DMM (digital multimeter) to the positive (+)
terminal of a battery and the other meter lead to the "B" terminal of the starter
solenoid and then cranks the engine. During cranking, the voltmeter displays a
reading of 878 mV.
Technician A says this reading indicates the positive battery cable has very high
resistance.
Technician A only
Technician B says this reading indicates that the starter armature is defective.
Who is right?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
Technician A says proper starter operation depends on the battery being at a 95%
charge and battery cables being of the correct size (gauge) and having no more
than 0.8-volt drop.
Technician B says voltage-drop testing includes cranking the engine, measuring the
drop in voltage from the battery to the starter, and measuring the drop in voltage
from the negative terminal of the battery to the engine block.
Technician B only
Who is right?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
Which of the following could cause the starter to make a whining noise when
engaged?
Defective starter drive a. Defective starter drive
b. Defective solenoid
c. Open pull-in winding
d. Worn armature commutator
, Two bulbs are connected in parallel to a 12 volt battery. Another bulb is added in
parallel.
Technician A says that the third bulb will be dimmer than the other two bulbs due to
reduced current flow through the filament of the bulb.
Technician B says that the amount of current flowing from the battery will decrease
due to the extra load.
Neither Technician A nor B
Who is right?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
Two bulbs are connected in parallel to a 12 volt battery. One bulb has a resistance of
6 ohms and the other has a resistance of 2 ohms.
Technician A says that only the 2 ohm bulb will light because all the current will flow
through the 6 ohms bulb.
Technician B says that the 6 ohm bulb will be dimmer than the 2 ohm bulb.
Technician B only Who is right?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
What causes a fuse to blow ?
a. A sudden decrease in current through the circuit
Both B & C
b. An increase in current through the circuit
c. A decrease in circuit resistance
d. Both B & C
Many ground straps are uninsulated and braided because _______ ?
a. They are less expensive than conventional wire
Both B & C
b. They are more flexible to allow movement of the engine without breaking the wire
c. They dampen Radio-Frequency Interference (RFI)
d. Both B & C
Technician A says that a test light should light on both test points of the fuse if it is ok.
Technician B says that the fuse is defective if a test light only lights on one side of the
fuse.
Who is right?
Both Technicians A and B
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
Which statement is true about fuse ratings ?
a. The fuse rating should be less than the maximum current for the circuit.
Both B & C
b. The fuse rating should be higher than the normal current for the circuit.
c. 80% of the fuse rating should equal the current in the circuit.
d. Both B & C
Questions and CORRECT Answers
A technician connects one lead of a DMM (digital multimeter) to the positive (+)
terminal of a battery and the other meter lead to the "B" terminal of the starter
solenoid and then cranks the engine. During cranking, the voltmeter displays a
reading of 878 mV.
Technician A says this reading indicates the positive battery cable has very high
resistance.
Technician A only
Technician B says this reading indicates that the starter armature is defective.
Who is right?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
When performing a load test on a battery, a technician finds that the battery
voltage drops below specifications. Which of the following is the MOST likely
repair?
Replace the battery
a. Recharge the battery and return it to service
b. Recharge the battery and retest it
c. Replace the battery
d. Replace the voltage regulator
, Two technicians are describing battery charging.
Technician A says to remove the surface charge from a recently charged battery and
apply a 300-ampere load across the adapters for 15 seconds.
Technician B says to remove the surface charge from batteries, which have been in
storage.
Technician A only
Who is right?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
A technician connects one lead of a DMM (digital multimeter) to the positive (+)
terminal of a battery and the other meter lead to the "B" terminal of the starter
solenoid and then cranks the engine. During cranking, the voltmeter displays a
reading of 878 mV.
Technician A says this reading indicates the positive battery cable has very high
resistance.
Technician A only
Technician B says this reading indicates that the starter armature is defective.
Who is right?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
Technician A says proper starter operation depends on the battery being at a 95%
charge and battery cables being of the correct size (gauge) and having no more
than 0.8-volt drop.
Technician B says voltage-drop testing includes cranking the engine, measuring the
drop in voltage from the battery to the starter, and measuring the drop in voltage
from the negative terminal of the battery to the engine block.
Technician B only
Who is right?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
Which of the following could cause the starter to make a whining noise when
engaged?
Defective starter drive a. Defective starter drive
b. Defective solenoid
c. Open pull-in winding
d. Worn armature commutator
, Two bulbs are connected in parallel to a 12 volt battery. Another bulb is added in
parallel.
Technician A says that the third bulb will be dimmer than the other two bulbs due to
reduced current flow through the filament of the bulb.
Technician B says that the amount of current flowing from the battery will decrease
due to the extra load.
Neither Technician A nor B
Who is right?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
Two bulbs are connected in parallel to a 12 volt battery. One bulb has a resistance of
6 ohms and the other has a resistance of 2 ohms.
Technician A says that only the 2 ohm bulb will light because all the current will flow
through the 6 ohms bulb.
Technician B says that the 6 ohm bulb will be dimmer than the 2 ohm bulb.
Technician B only Who is right?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
What causes a fuse to blow ?
a. A sudden decrease in current through the circuit
Both B & C
b. An increase in current through the circuit
c. A decrease in circuit resistance
d. Both B & C
Many ground straps are uninsulated and braided because _______ ?
a. They are less expensive than conventional wire
Both B & C
b. They are more flexible to allow movement of the engine without breaking the wire
c. They dampen Radio-Frequency Interference (RFI)
d. Both B & C
Technician A says that a test light should light on both test points of the fuse if it is ok.
Technician B says that the fuse is defective if a test light only lights on one side of the
fuse.
Who is right?
Both Technicians A and B
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B
Which statement is true about fuse ratings ?
a. The fuse rating should be less than the maximum current for the circuit.
Both B & C
b. The fuse rating should be higher than the normal current for the circuit.
c. 80% of the fuse rating should equal the current in the circuit.
d. Both B & C
