TTT1 STUDY GUIDE UPDATED 25/26 QUESTIONS AND ANSWERS
GUARANTEED PASS
What is a crown block? - ---Answers-----An upper sheave
assembly on top of the structure
What motion indicates retract the boom? - ---Answers-----Fists
made and thumbs touching
For power lines rated 50 kv, the minimum clearance between the
lines and any part of the crane or load shall be ? - ---Answers--
---10 feet
What motion indicates easing the crane load? - ---Answers-----
Point into the air and spin finger
An operator must take a stop signal from anyone during the
operations ? T or F? - ---Answers-----True
The basket slings on a pole preform what function? - ---
Answers-----Support all the combined weight
How often should gin poles have a documented job inspection - -
--Answers-----Before each job
, The three main components that make up a fall arrest system? -
---Answers-----Anchorage, full body harness, connectors
When using a fall restraint system, what is the minimum
anchorage allowed? - ---Answers-----1000lbs
A hoist should be designed to withstand a minimum of , the
maximum intended line pull? - ---Answers-----2 times
What are some of the working parts of a hoist? - ---Answers---
--Hydraulic pump, motor and control levers
In a high vehicle traffic area where work is taking place, the
following should occur ? - ---Answers-----Use a indicated
signal person with a high vis vest
If the wire rope load line on a base mounted hoist has a breaking
strength of 21,500 lbs. What is the actual working load limit when
lifting personnel ? - ---Answers-----4300, divide by 5
What device is used to allow a climber to work hands free? - ---
Answers-----Positioning device
GUARANTEED PASS
What is a crown block? - ---Answers-----An upper sheave
assembly on top of the structure
What motion indicates retract the boom? - ---Answers-----Fists
made and thumbs touching
For power lines rated 50 kv, the minimum clearance between the
lines and any part of the crane or load shall be ? - ---Answers--
---10 feet
What motion indicates easing the crane load? - ---Answers-----
Point into the air and spin finger
An operator must take a stop signal from anyone during the
operations ? T or F? - ---Answers-----True
The basket slings on a pole preform what function? - ---
Answers-----Support all the combined weight
How often should gin poles have a documented job inspection - -
--Answers-----Before each job
, The three main components that make up a fall arrest system? -
---Answers-----Anchorage, full body harness, connectors
When using a fall restraint system, what is the minimum
anchorage allowed? - ---Answers-----1000lbs
A hoist should be designed to withstand a minimum of , the
maximum intended line pull? - ---Answers-----2 times
What are some of the working parts of a hoist? - ---Answers---
--Hydraulic pump, motor and control levers
In a high vehicle traffic area where work is taking place, the
following should occur ? - ---Answers-----Use a indicated
signal person with a high vis vest
If the wire rope load line on a base mounted hoist has a breaking
strength of 21,500 lbs. What is the actual working load limit when
lifting personnel ? - ---Answers-----4300, divide by 5
What device is used to allow a climber to work hands free? - ---
Answers-----Positioning device
