UNITIZED STRUCTURAL BODY REPAIR TEST QUESTIONS AND ALL
ANSWERS CORRECT (NEWEST)
Which of the following best describes ultra-high strength steel, or UHSS?
ANSWER can be heated in accordance with the manufacturer's instructions.
Heat can be applied for a total of three minutes if a manufacturer sets a three-
minute time limit for heating HSS (ultra-high strength steel).
When ANSWER melts, heat crayons show their rated temperature.
If the HSS pieces are kinked, they should be replaced.
If an overpull happens, the part usually has to be replaced.
The amount of force or pressure needed to induce a -ANSWER tear is known as
the tensile straight.
One way to identify HSS is to consult the body repair handbook.
Which of the following techniques should be used to weld unibody structural
panels? Mi welding in response
ANSWER 75% AR/25% CO2 is the suggested shielding gas for welding steels
in collision repair.
One possible cause of porosity in the mig weld is a shortage of shielding gas.
One way to reduce metal distortion and tearing during pulling is to use
numerous pulls.
Which of the following fuse base metal in a weld joint using heat from an
electric arc? ANSWER flux coated
When welding, what safety measures should the mechanic follow? ANSWER
all of the above.
The mechanics should ANSWER up the welder's heat and wire speed setting to
ANSWERS CORRECT (NEWEST)
Which of the following best describes ultra-high strength steel, or UHSS?
ANSWER can be heated in accordance with the manufacturer's instructions.
Heat can be applied for a total of three minutes if a manufacturer sets a three-
minute time limit for heating HSS (ultra-high strength steel).
When ANSWER melts, heat crayons show their rated temperature.
If the HSS pieces are kinked, they should be replaced.
If an overpull happens, the part usually has to be replaced.
The amount of force or pressure needed to induce a -ANSWER tear is known as
the tensile straight.
One way to identify HSS is to consult the body repair handbook.
Which of the following techniques should be used to weld unibody structural
panels? Mi welding in response
ANSWER 75% AR/25% CO2 is the suggested shielding gas for welding steels
in collision repair.
One possible cause of porosity in the mig weld is a shortage of shielding gas.
One way to reduce metal distortion and tearing during pulling is to use
numerous pulls.
Which of the following fuse base metal in a weld joint using heat from an
electric arc? ANSWER flux coated
When welding, what safety measures should the mechanic follow? ANSWER
all of the above.
The mechanics should ANSWER up the welder's heat and wire speed setting to
