1
For Expert help and assignment solutions, +254707240657
MKC SWE Study Guide (MKC Knight
donation) Questions and Answers (100%
Correct Answers) Already Graded A+
Types of gate valves [ ANS: ] Parallel and wedge
CAGE code [ ANS: ] Commercial and government entity code
Hard fouling in a heat exchanger [ ANS: ] Deposits that
significantly reduce heat transfer efficiency.
© 2025 Assignment Expert
Hydraulic actuator bench test pressure [ ANS: ] On and one half
times the operating pressure and hold for five minutes
Modes of operation on Ultra-Sep OWS [ ANS: ] Operate and clean
Guru01 - Stuvia
mode
Component boosting pressure in Ultra Sep OWS [ ANS: ] Process
Pump
Ensign changes since 1776 [ ANS: ] 26
Improperly seated piston rings indication [ ANS: ] Dull appearance
and may have areas of black carbon where blow by is occurring.
Checks for properly seated piston rings [ ANS: ] Visual and
operational parameters.
AC generator windings touching [ ANS: ] Open Circuit
Process of converting mechanical energy to electrical energy [
ANS: ] Electromagnetic induction.
NSTM chapter for DEMPS maintenance [ ANS: ] Not specified in the
notes.
SSS in clutches [ ANS: ] Not specified in the notes.
, 2
For Expert help and assignment solutions, +254707240657
Brakes used in gas turbines [ ANS: ] Disk brake
Hydraulic filter change frequency on jet drive powered HPU [ ANS:
] Not specified in the notes.
Types of line shaft bearings [ ANS: ] Ring-oiled and disc-oiled
Max angle on the E-BAC unit for operation [ ANS: ] Not specified in
the notes.
Fuel sample test before acceptance [ ANS: ] Clear and bright
Fluid spec for hot flushing on L/O systems [ ANS: ] MIL-PRF
© 2025 Assignment Expert
Torque for pressure vessel end cap on village marine R/O [ ANS: ]
Do not overtighten
Dew point in HVAC unit [ ANS: ] The point at which condensation
Guru01 - Stuvia
develops.
Oil filter on HP air compressor [ ANS: ] Compression cylinders are
open to the crankcase.
Minimum PPM of bromine in shoreside unit [ ANS: ] 0
Green lights on HUD of SCBA mask [ ANS: ] 2 means ¾-full
Next step after Evaluation in risk management process [ ANS: ] Not
specified in the notes.
Certifying OBTT members onboard [ ANS: ] CO/OIC
Results from ALS oil sample analysis [ ANS: ] Severe, Abnormal,
caution, and normal
Coast Guard's primary corrosion prevention program [ ANS: ]
CPAC Corrosion Prevention and Control.
No calibration sticker requirement [ ANS: ] Non critical gauges
For Expert help and assignment solutions, +254707240657
MKC SWE Study Guide (MKC Knight
donation) Questions and Answers (100%
Correct Answers) Already Graded A+
Types of gate valves [ ANS: ] Parallel and wedge
CAGE code [ ANS: ] Commercial and government entity code
Hard fouling in a heat exchanger [ ANS: ] Deposits that
significantly reduce heat transfer efficiency.
© 2025 Assignment Expert
Hydraulic actuator bench test pressure [ ANS: ] On and one half
times the operating pressure and hold for five minutes
Modes of operation on Ultra-Sep OWS [ ANS: ] Operate and clean
Guru01 - Stuvia
mode
Component boosting pressure in Ultra Sep OWS [ ANS: ] Process
Pump
Ensign changes since 1776 [ ANS: ] 26
Improperly seated piston rings indication [ ANS: ] Dull appearance
and may have areas of black carbon where blow by is occurring.
Checks for properly seated piston rings [ ANS: ] Visual and
operational parameters.
AC generator windings touching [ ANS: ] Open Circuit
Process of converting mechanical energy to electrical energy [
ANS: ] Electromagnetic induction.
NSTM chapter for DEMPS maintenance [ ANS: ] Not specified in the
notes.
SSS in clutches [ ANS: ] Not specified in the notes.
, 2
For Expert help and assignment solutions, +254707240657
Brakes used in gas turbines [ ANS: ] Disk brake
Hydraulic filter change frequency on jet drive powered HPU [ ANS:
] Not specified in the notes.
Types of line shaft bearings [ ANS: ] Ring-oiled and disc-oiled
Max angle on the E-BAC unit for operation [ ANS: ] Not specified in
the notes.
Fuel sample test before acceptance [ ANS: ] Clear and bright
Fluid spec for hot flushing on L/O systems [ ANS: ] MIL-PRF
© 2025 Assignment Expert
Torque for pressure vessel end cap on village marine R/O [ ANS: ]
Do not overtighten
Dew point in HVAC unit [ ANS: ] The point at which condensation
Guru01 - Stuvia
develops.
Oil filter on HP air compressor [ ANS: ] Compression cylinders are
open to the crankcase.
Minimum PPM of bromine in shoreside unit [ ANS: ] 0
Green lights on HUD of SCBA mask [ ANS: ] 2 means ¾-full
Next step after Evaluation in risk management process [ ANS: ] Not
specified in the notes.
Certifying OBTT members onboard [ ANS: ] CO/OIC
Results from ALS oil sample analysis [ ANS: ] Severe, Abnormal,
caution, and normal
Coast Guard's primary corrosion prevention program [ ANS: ]
CPAC Corrosion Prevention and Control.
No calibration sticker requirement [ ANS: ] Non critical gauges
