ICC Vapor Recovery 2 - Questions With A+
Solutions
Save
Terms in this set (60)
After backfilling the c. 0.5 inches WC
vapor return and vent
lines, the maximum
pressure drop through
the system shall not
exceed ________at 60 cubic
feet per hour as
determined by TP-201.4,
Dynamic Backpressure.
a. 0.75 inches WC
b. 0.5 inches WC
c. 0.32 inches WC
d. 0.55 inches WC
CARB's most recent a. EVR (enhanced vapor recovery)
vapor recovery
regulations are known as:
a. EVR (enhanced vapor
recovery)
b. CVR (California vapor
recovery)
c. PVR (protective vapor
recovery)
d. ORVR (onboard
refueling vapor recovery)
,A valve installed in a a. breakaway
motor-vehicle fueling
hose designed to
separate with little or no
product
a. breakaway
b. hose clamp
c. sheer valve
d. flow limiter
A Gilbarco Vapor c. 75
VAC/OPW Vapor Saver
system is consdered to
have a vapor recovery
equipment defect (VRED)
if the vapor escape guard
on an OPW 12 VW nozzle
is missing or damaged on
at least ____ % of the
circumference of the
device.
a. 25
b. 50
c. 75
d. 100
The two point Phase I d. vapor recovery adaptor....
vapor recovery system
requires that a separate
vapor recovery riser pipe
be installed in the tank
and be equipped with a:
a. drop tube
b. locking block valve
c. pressure/vacuum vent
d. vapor recovery
adaptor
, When removing liquid a. managed as hazardous waste
from a sump or spill
bucket and the liquid
contains fuel, it must be:
a. managed as hazardous
waste
b. pumped into a bucket
to evaporate
c. scooped or balled
onto the concrete pad
d. put it in a sealed
container and put into a
dump
One of the approved c. 95
methods of overfill
prevention is to have an
overfill device that will
automatically shut off the
fill to the tank when the
tank is at a maximum of
____ % full.
a. 80
b. 90
c. 95
d. 99
Solutions
Save
Terms in this set (60)
After backfilling the c. 0.5 inches WC
vapor return and vent
lines, the maximum
pressure drop through
the system shall not
exceed ________at 60 cubic
feet per hour as
determined by TP-201.4,
Dynamic Backpressure.
a. 0.75 inches WC
b. 0.5 inches WC
c. 0.32 inches WC
d. 0.55 inches WC
CARB's most recent a. EVR (enhanced vapor recovery)
vapor recovery
regulations are known as:
a. EVR (enhanced vapor
recovery)
b. CVR (California vapor
recovery)
c. PVR (protective vapor
recovery)
d. ORVR (onboard
refueling vapor recovery)
,A valve installed in a a. breakaway
motor-vehicle fueling
hose designed to
separate with little or no
product
a. breakaway
b. hose clamp
c. sheer valve
d. flow limiter
A Gilbarco Vapor c. 75
VAC/OPW Vapor Saver
system is consdered to
have a vapor recovery
equipment defect (VRED)
if the vapor escape guard
on an OPW 12 VW nozzle
is missing or damaged on
at least ____ % of the
circumference of the
device.
a. 25
b. 50
c. 75
d. 100
The two point Phase I d. vapor recovery adaptor....
vapor recovery system
requires that a separate
vapor recovery riser pipe
be installed in the tank
and be equipped with a:
a. drop tube
b. locking block valve
c. pressure/vacuum vent
d. vapor recovery
adaptor
, When removing liquid a. managed as hazardous waste
from a sump or spill
bucket and the liquid
contains fuel, it must be:
a. managed as hazardous
waste
b. pumped into a bucket
to evaporate
c. scooped or balled
onto the concrete pad
d. put it in a sealed
container and put into a
dump
One of the approved c. 95
methods of overfill
prevention is to have an
overfill device that will
automatically shut off the
fill to the tank when the
tank is at a maximum of
____ % full.
a. 80
b. 90
c. 95
d. 99
