Forklift OSHA training test UPDATED ACTUAL Questions and CORRECT Answers

Forklift OSHA training test UPDATED ACTUAL Questions and CORRECT

Answers



1. When parking or leaving your truck, you should: All of the above
A. Park or leave your truck in a safe area away from
traffic.
B. Lower the forks until they are flat on the floor.
C. Turn-off the engine.
D. Set the parking brake and set the directional control
to neutral.
E. All of the above.
2. All industrial trucks (lift trucks) are equipped with con- True
trols which allow you to
raise/lower and tilt the forks.
A. True
B. False
3. Of the three load positions illustrated below, which is 3
the most stable?


4. Rear wheel steering is used on lift trucks because it
gives the operator greater control True
when using the forks.
A. True
B. False
5. Always check the air pressure in tires from the side, not False
by facing the tread.
A. True
B. False
6. All industrial trucks (lift trucks) are equipped with a False
clutch.

, A. True
B. False
Air-cooled powered
7. Which of the following is NOT a type of lift truck?
A. Gasoline Powered
B. Diesel Powered
C. Electric Powered
D. Air-cooled Powered
True
8. Wide and long loads are more unstable than other
types of loads.
A. True
B. False
9. 9. If the lift mechanism on your lift fails, you should try False
to repair the chains or hydraulic
system yourself.
A. True
B. False
10. The load capacity of a truck can be found on its data True
plate.
A. True
B. False
11. It is part of your job to complete a Daily Operator's
Report after you have thoroughly True
inspected your lift truck.
A. True
B. False
12. If your truck starts to tip over:
A. Do not jump. All of the above



2/6