NICET LVL1-2 FAS TOP 112 Questions and Answers

10/1/25, 9:27 AM NICET FAS TOP 112 Questions for LVL1-2 <span style="color:#000;font-weight:bold;">110+</span> (2025-2026 A+ Graded) Exam…




NICET LVL1-2 FAS TOP 112 Questions and
Answers
Question 1
A factory Uses a motorized gate opener for access to there facility. The fire alarm
panel uses an on-board relay to open the gate upon alarm, What operation or signal
is required of this circuit should an open occur? (broken wire to gate opener)?
Correct Answer
Trouble signal or gate operation would occur.



Question 2
The _______ is/are responsible for keeping all installation documents related to their
installations.
Correct Answer
System Owner



Question 3
Inspections, testing, or maintenance shall be permitted to be done by a person or
organization other then the owner if___________.
Correct Answer
Conducted under a written contract.



Question 4
Who is responsible for the inspection, testing and maintenance of the fire alarm
system?
Correct Answer
The Owner




Page 1 of 23
1/23

,10/1/25, 9:27 AM NICET FAS TOP 112 Questions for LVL1-2 <span style="color:#000;font-weight:bold;">110+</span> (2025-2026 A+ Graded) Exam…




Question 5
When are visual alarm notification devices required to be tested?
Correct Answer
During the acceptance test and annually thereafter.



Question 6
While performing regularly scheduled testing of a fire alarm system, you discover that
it is impaired. Who does NFPA 72 require you to notify?
Correct Answer
The system owner of their designated representative.



Question 7
Which of the following best describes how often a spot type smoke detector should
be tested for sensitivity using a calibrated test method.
Correct Answer
After one year and every alternate year thereafter.



Question 8
What is the required test frequency for a pressure-type water flow initiating device?
Correct Answer
Semiannually.



Question 9
During an annual test of a fire alarm system, you simulate a detectors operation. On
the inspection record you must now________.
Correct Answer
Indicate which device (Location and Type) was simulated.




Page 2 of 23
2/23

, 10/1/25, 9:27 AM NICET FAS TOP 112 Questions for LVL1-2 <span style="color:#000;font-weight:bold;">110+</span> (2025-2026 A+ Graded) Exam…




Question 10
How often must household fire alarm system smoke detectors be tested by a
qualified alarm tech?
Correct Answer
Never the home owner can do this.



Question 11
While testing a fire alarm system you remove a two-wire smoke detector from its
plug-in base on a Class B type circuit. What alarm capability would you expect from
the other detectors on that circuit?
Correct Answer
Activated detectors between the control unit and that detector base should alarm.



Question 12
If a defect or malfunction is not corrected at the conclusion of system inspection,
testing, or maintenance, the responsible party shall be informed of the impairment
_______.
Correct Answer
In writing, within 24 hours



Question 13
When testing a water level supervisory switch serving a pressurized water storage
tank, a signal must be indicated whenever the water_______ from the normal level.
Correct Answer
rises or falls 3 inches



Question 14
NFPA 72 requires that the fire alarm contractor complete all portions of the record of
completion_________.
Correct Answer
for the portion of the system for which they had responsibility.




Page 3 of 23
3/23