Elevator Mechanic Exam 2025/2026
Exam Questions and Correct Answers |
New Update
A Latching relay: Used for call registration,direction selection or as selector
relays
Two types are: Set/Rest are electrical and Mechanical Latching relays
Need to know latching relay symbol, Its a box with shaded triangle in lower
right hand corner. - 🧠ANSWER ✔✔Which relay do you need to Order
710 Pg, 7
RPM = 60 ∙ ƒ ÷ P÷2 =
Step 1. 60 x Frequency (Hz.) =
,Step 2. Poles ÷ 2 =
Take answer 1 and ÷ by answer 2 = - 🧠ANSWER ✔✔Know the formula for
RPM
435 Pg. 5
If you are referring to a megohm meter, it is a test of the insulation
properties of such things as electric wiring, motor windings and high power
antenna mounts.
We use a "megger" or "meg out" electrical wiring and equipment to see if it
is shorted to ground or the frame in any way.
The megger uses much higher voltages to check resistance than a normal
Volt-ohm meter.
Minimum resistance is 1 Meg Ohm - 🧠ANSWER ✔✔Know what a Megger
is and what it does
,636 Pg. 13
(1) A parallel connection. (2) A resistive element placed across the
terminals of an armature to bypass a portion of the current. (3) A flexible
electrical conductor designed to conduct current around the mechanical
joint between two conductors. (4) The resistive element (Usually of very low
resistance) used in parallel with a DC ammeter movement to bypass a
calibrated portion of the total circuit current. - 🧠ANSWER ✔✔Shunt
Overloads
425 All Pages
Bad Ground - 🧠ANSWER ✔✔You are using a Temp Run Box and you get
shocked! Why!
520 Pg. 4
The bridle hitch can consist of two,three, or four single hitches (fig. 3-22),
used together to form a bridle hitch for hoisting an object
COPYRIGHT©JOSHCLAY 2025/2026. YEAR PUBLISHED 2025. COMPANY REGISTRATION NUMBER: 619652435. TERMS OF USE. PRIVACY
3
STATEMENT. ALL RIGHTS RESERVED
, A sling with two legs used to lift a 1,000 pound object will have 500 pounds
of the load on each leg when the sling angle is 90 degrees. The load stress
on each leg increases as the angle decreases; and if the sling angle was
30 degrees lifting the same 1,000 pound object, the load will be 1,000
pounds on each leg. Try to keep all sling angles greater than 45 degrees;
sling angles approaching 30 degrees are considered extremely hazardous
and must be avoided at all cost. - 🧠ANSWER ✔✔Bridal Hitch
128 Pg 17
Scaffolding should be tied to the structure using
#9 wire or tie-in devices. The first vertical tie
should be at the maximum height of 4 times the
narrowest base dimension. Additional ties are not
to exceed 26' vertically. Maximum horizontal
distance between ties is not to exceed 30'. - 🧠ANSWER ✔✔Scaffolding,
You have 32' of rise, you are using 3x5 scaffolding. Where will the tie off
points be ?
Exam Questions and Correct Answers |
New Update
A Latching relay: Used for call registration,direction selection or as selector
relays
Two types are: Set/Rest are electrical and Mechanical Latching relays
Need to know latching relay symbol, Its a box with shaded triangle in lower
right hand corner. - 🧠ANSWER ✔✔Which relay do you need to Order
710 Pg, 7
RPM = 60 ∙ ƒ ÷ P÷2 =
Step 1. 60 x Frequency (Hz.) =
,Step 2. Poles ÷ 2 =
Take answer 1 and ÷ by answer 2 = - 🧠ANSWER ✔✔Know the formula for
RPM
435 Pg. 5
If you are referring to a megohm meter, it is a test of the insulation
properties of such things as electric wiring, motor windings and high power
antenna mounts.
We use a "megger" or "meg out" electrical wiring and equipment to see if it
is shorted to ground or the frame in any way.
The megger uses much higher voltages to check resistance than a normal
Volt-ohm meter.
Minimum resistance is 1 Meg Ohm - 🧠ANSWER ✔✔Know what a Megger
is and what it does
,636 Pg. 13
(1) A parallel connection. (2) A resistive element placed across the
terminals of an armature to bypass a portion of the current. (3) A flexible
electrical conductor designed to conduct current around the mechanical
joint between two conductors. (4) The resistive element (Usually of very low
resistance) used in parallel with a DC ammeter movement to bypass a
calibrated portion of the total circuit current. - 🧠ANSWER ✔✔Shunt
Overloads
425 All Pages
Bad Ground - 🧠ANSWER ✔✔You are using a Temp Run Box and you get
shocked! Why!
520 Pg. 4
The bridle hitch can consist of two,three, or four single hitches (fig. 3-22),
used together to form a bridle hitch for hoisting an object
COPYRIGHT©JOSHCLAY 2025/2026. YEAR PUBLISHED 2025. COMPANY REGISTRATION NUMBER: 619652435. TERMS OF USE. PRIVACY
3
STATEMENT. ALL RIGHTS RESERVED
, A sling with two legs used to lift a 1,000 pound object will have 500 pounds
of the load on each leg when the sling angle is 90 degrees. The load stress
on each leg increases as the angle decreases; and if the sling angle was
30 degrees lifting the same 1,000 pound object, the load will be 1,000
pounds on each leg. Try to keep all sling angles greater than 45 degrees;
sling angles approaching 30 degrees are considered extremely hazardous
and must be avoided at all cost. - 🧠ANSWER ✔✔Bridal Hitch
128 Pg 17
Scaffolding should be tied to the structure using
#9 wire or tie-in devices. The first vertical tie
should be at the maximum height of 4 times the
narrowest base dimension. Additional ties are not
to exceed 26' vertically. Maximum horizontal
distance between ties is not to exceed 30'. - 🧠ANSWER ✔✔Scaffolding,
You have 32' of rise, you are using 3x5 scaffolding. Where will the tie off
points be ?
