IICL Container Inspector's Exam QUESTIONS
WITH COMPLETE SOLUTION GUIDE (A+ GRADED
100% VERIFIED) LATEST VERSION 2025!!
Save
Terms in this set (220)
Which of the following A. A loose door gasket
defects requires repair?
A. A loose door gasket
B. A bent J-bar that does
not affect door operation
C. A dent 13mm (1/2 in)
deep on the door sill
D. Four dents, each 11mm
(7/16 in) deep, on
contiguous outboard
corrugations of a roof
panel
https://quizlet.com/1062708345/iicl-container-inspectors-exam-questions-with-complete-solution-guide-a-graded-100-verified-latest-version-2025-flas… 1/37
,7/28/25, 9:31 PM IICL Container Inspector's Exam QUESTIONS WITH COMPLETE SOLUTION GUIDE (A+ GRADED 100% VERIFIED) LATEST VE…
Of the following C. Coffee beans remaining inside the container as
conditions in a dry-van might occur after a sweep out
container, which one
would require cleaning?
A. Raised mud foot prints
in excess of what might
normally remain after a
sweep out
B. Dry dust covering dried
floor stains as might
normally be found after a
sweep out
C. Coffee beans remaining
inside the container as
might occur after a sweep
out
D. Polyurethane beads as
might be expected to
lodge in grooves between
floorboards after a sweep
out
https://quizlet.com/1062708345/iicl-container-inspectors-exam-questions-with-complete-solution-guide-a-graded-100-verified-latest-version-2025-flas… 2/37
,7/28/25, 9:31 PM IICL Container Inspector's Exam QUESTIONS WITH COMPLETE SOLUTION GUIDE (A+ GRADED 100% VERIFIED) LATEST VE…
An Equipment B. Convention for Safe Containers (CSC) regulations
Interchange Receipt (EIR), through the ACEP Program
based on an inspection
with no damage found,
can be evidence of a
container's compliance
with: A. Australian Timber
Component Treatment
Regulations B. Convention
for Safe Containers (CSC)
regulations through the
ACEP Program
C. Transport under
custom's seal (TIR)
regulations D.
International Standards
Organization (ISO) CEDEX
codes regulations
The top of a replacement A. 50-55mm (2-2 3/16 in)
plastic ventilator should
be centered what distance
from the top side rail? A.
50-55mm (2-2 3/16 in) B.
70-75mm (2 5/8 - 3 in)
C. 100mm (4in) D. 150mm
(6 in)
https://quizlet.com/1062708345/iicl-container-inspectors-exam-questions-with-complete-solution-guide-a-graded-100-verified-latest-version-2025-flas… 3/37
, 7/28/25, 9:31 PM IICL Container Inspector's Exam QUESTIONS WITH COMPLETE SOLUTION GUIDE (A+ GRADED 100% VERIFIED) LATEST VE…
When must a reference C. When there is a bowing over the entire bottom side
line extend the full length rail
of a bottom side rail? A.
When there are two or
more areas of damage on
the bottom side rail B.
When there is a sharp
bend in the bottom side
rail
C. When there is a bowing
over the entire bottom
side rail D. When there is
additional damage to the
bottom side rail so that
the reference line cannot
be positioned over the
ends of the damage
Which of the following is B. Tunnel rail
NOT a transverse
structural member of the
container?
A. Front sill B. Tunnel rail
C. Rear header
D. Crossmember
A steel corner fitting is B. 45 degrees
being replaced. To ensure
better weld penetration,
IICL recommends that the
edges of parts adjacent to
the corner fitting be
ground to a minimum
bevel of? A. 30 degrees B.
45 degrees
C. 55 degrees D. 60
degrees
https://quizlet.com/1062708345/iicl-container-inspectors-exam-questions-with-complete-solution-guide-a-graded-100-verified-latest-version-2025-flas… 4/37