Mass 1A Hoisting Study Guide Questions With Correct
Answers
1. Where should a license or temporary permit be located during time of
| | | | | | | | | | |
| operation of equipment: Shall be carried ON the person at all times; in the
| | | | | | | | | | | | | |
| caseof a temporary permit the person shall also carry their drivers license
| | | | | | | | | | | |
2. Whats the fine for violating section 53, 53a or 54: No less than $500 and
| | | | | | | | | | | | | | |
| no more than $3,000, or by imprisonment of no more than 3 months, or both fine and
| | | | | | | | | | | | | | | |
imprisonment
|
3. Whats the fine for permitting an unlicensed person to operate machinery: -
| | | | | | | | | | |
No less than $1,000 and no more than $3,000, or imprisonment of no more than
| | | | | | | | | | | | | | | |
| 3months, or both fine and imprisonment
| | | | | |
4. Whats the fine for violating section 42 to 51, or prevents an inspector from
| | | | | | | | | | | | |
entering the premises: No less than $10 no more than $300, or by
| | | | | | | | | | | | | | |
| imprisonmentof upto 3 months | | | |
5. Whats the purpose of 520CMR 6.00: To establish reasonable requirements
| | | | | | | | | |
toprotect the public safety of the citizens of the commonwealth from the hazards
| | | | | | | | | | | | | |
1 |/ |23
,| inherent in the operation of housting machinery by establishing min standards
| | | | | | | | | |
| neccessary to obtain a hoisting machinery operators license or temp permit
| | | | | | | | | |
6. ANSI: American National Standards Institute
| | | |
7. Apprentice license: A document issued by the dept upon proof of registratio at a
| | | | | | | | | | | | |
| training facility and with the division of apprentice training within the dept of labor
| | | | | | | | | | | | |
standards, which enables the holder to operate hoisting machinery under the direct
| | | | | | | | | | | |
guidance and supervision of a duly licensed person licensed to operate the category of
| | | | | | | | | | | | | |
| hoisting machinery for which documentation is issued
| | | | | |
8. ASME: American Society of Mechanical Engineers
| | | | |
9. cargo: A load, quantity or volume that can be processed or transported
| | | | | | | | | | |
10. Apprentice licensee: A person, 18 or older, registered with the dept of labor
| | | | | | | | | | | |
standards and has obtained an apprentice license to operate while under direct
| | | | | | | | | | | |
| guidance and supervision of a duly licensed person
| | | | | | |
11. Chief: The chief of inspections-mechanical of the dept of public safety
| | | | | | | | | |
12. Compact hoisting machinery: Machinery wirh a gross vehicle weight not ex-
| | | | | | | | | |
ceeding 10,000 lbs, excluding Class 1, Class 3 and Class 4 hoisting machinery
| | | | | | | | | | | | |
as listed in 520CMR 6.10. Machinery operated under temp permit may not exceed
| | | | | | | | | | | |
8,000lbs
|
13. DAT: Division of Apprentice Training
| | | |
2 |/ |23
,14. Department: Dept of Public Safety
| | | |
15. DOT: Department of Transportation
| | |
16. Emergency procedure: Actions required to be taken when imminent danger
| | | | | | | | |
may occur to prevent damage to life, property, or to public safety
| | | | | | | | | | | |
17. Company license: Issued by an exempt company that has a dept approved in
| | | | | | | | | | | |
service training program and is only valid for machinery used on company property
| | | | | | | | | | | | |
3 |/ |23
, 18. fork lift: Any mobile powered truck used to carry, push, lift, stack or tier materials,
| | | | | | | | | | | | | |
EXCLUDING earth moving, over the road haulage trucks and equipment which was
| | | | | | | | | | | |
designed to move earth but modified to accept forks
| | | | | | | | |
19. Hoisting machinery: Derricks, cableways, machinery used for discharging car-
| | | | | | | |
goes, and temp elevator cars used on excavation work or hoisting building materials,
| | | | | | | | | | | | |
when the motive power to operate such machinery is mechanical and other than
| | | | | | | | | | | | |
| steam, and any other equipment that has the MIN capability of hoisting a load
| | | | | | | | | | | | |
| HIGHER THAN 10 FT, and either the capability of lifting loads GREATER THAN 500
| | | | | | | | | | | | |
| LBS or the capacity of the bucket EXCEEDS 1/4 CUBIC YARDS; overhead bridge
| | | | | | | | | | | |
cranes, electric orair driven hoists, specialty equipment as catagorized under520CMR
| | | | | | | | | | | |
| 6.00
20. incedent: A situation that results in serious injury, property damage or any
| | | | | | | | | | |
condition that is necessary for the preservation of the public health or safety
| | | | | | | | | | | | |
21. Injury and incedent documentation: A form furnished by the department de-
| | | | | | | | | |
tailing all specific info regarding any serious injury, property damage or mechanical
| | | | | | | | | | | |
failure that may have occurred
| | | | |
22. inspector: A District Engineering Inspector employed by the Department | | | | | | | |
23. Manufacturer approved attachment: Attachable equipment tailored to performa | | | | | | | |
| particular task, designed or approved for use in accordance with the equipment
| | | | | | | | | | |
4 |/ |23
Answers
1. Where should a license or temporary permit be located during time of
| | | | | | | | | | |
| operation of equipment: Shall be carried ON the person at all times; in the
| | | | | | | | | | | | | |
| caseof a temporary permit the person shall also carry their drivers license
| | | | | | | | | | | |
2. Whats the fine for violating section 53, 53a or 54: No less than $500 and
| | | | | | | | | | | | | | |
| no more than $3,000, or by imprisonment of no more than 3 months, or both fine and
| | | | | | | | | | | | | | | |
imprisonment
|
3. Whats the fine for permitting an unlicensed person to operate machinery: -
| | | | | | | | | | |
No less than $1,000 and no more than $3,000, or imprisonment of no more than
| | | | | | | | | | | | | | | |
| 3months, or both fine and imprisonment
| | | | | |
4. Whats the fine for violating section 42 to 51, or prevents an inspector from
| | | | | | | | | | | | |
entering the premises: No less than $10 no more than $300, or by
| | | | | | | | | | | | | | |
| imprisonmentof upto 3 months | | | |
5. Whats the purpose of 520CMR 6.00: To establish reasonable requirements
| | | | | | | | | |
toprotect the public safety of the citizens of the commonwealth from the hazards
| | | | | | | | | | | | | |
1 |/ |23
,| inherent in the operation of housting machinery by establishing min standards
| | | | | | | | | |
| neccessary to obtain a hoisting machinery operators license or temp permit
| | | | | | | | | |
6. ANSI: American National Standards Institute
| | | |
7. Apprentice license: A document issued by the dept upon proof of registratio at a
| | | | | | | | | | | | |
| training facility and with the division of apprentice training within the dept of labor
| | | | | | | | | | | | |
standards, which enables the holder to operate hoisting machinery under the direct
| | | | | | | | | | | |
guidance and supervision of a duly licensed person licensed to operate the category of
| | | | | | | | | | | | | |
| hoisting machinery for which documentation is issued
| | | | | |
8. ASME: American Society of Mechanical Engineers
| | | | |
9. cargo: A load, quantity or volume that can be processed or transported
| | | | | | | | | | |
10. Apprentice licensee: A person, 18 or older, registered with the dept of labor
| | | | | | | | | | | |
standards and has obtained an apprentice license to operate while under direct
| | | | | | | | | | | |
| guidance and supervision of a duly licensed person
| | | | | | |
11. Chief: The chief of inspections-mechanical of the dept of public safety
| | | | | | | | | |
12. Compact hoisting machinery: Machinery wirh a gross vehicle weight not ex-
| | | | | | | | | |
ceeding 10,000 lbs, excluding Class 1, Class 3 and Class 4 hoisting machinery
| | | | | | | | | | | | |
as listed in 520CMR 6.10. Machinery operated under temp permit may not exceed
| | | | | | | | | | | |
8,000lbs
|
13. DAT: Division of Apprentice Training
| | | |
2 |/ |23
,14. Department: Dept of Public Safety
| | | |
15. DOT: Department of Transportation
| | |
16. Emergency procedure: Actions required to be taken when imminent danger
| | | | | | | | |
may occur to prevent damage to life, property, or to public safety
| | | | | | | | | | | |
17. Company license: Issued by an exempt company that has a dept approved in
| | | | | | | | | | | |
service training program and is only valid for machinery used on company property
| | | | | | | | | | | | |
3 |/ |23
, 18. fork lift: Any mobile powered truck used to carry, push, lift, stack or tier materials,
| | | | | | | | | | | | | |
EXCLUDING earth moving, over the road haulage trucks and equipment which was
| | | | | | | | | | | |
designed to move earth but modified to accept forks
| | | | | | | | |
19. Hoisting machinery: Derricks, cableways, machinery used for discharging car-
| | | | | | | |
goes, and temp elevator cars used on excavation work or hoisting building materials,
| | | | | | | | | | | | |
when the motive power to operate such machinery is mechanical and other than
| | | | | | | | | | | | |
| steam, and any other equipment that has the MIN capability of hoisting a load
| | | | | | | | | | | | |
| HIGHER THAN 10 FT, and either the capability of lifting loads GREATER THAN 500
| | | | | | | | | | | | |
| LBS or the capacity of the bucket EXCEEDS 1/4 CUBIC YARDS; overhead bridge
| | | | | | | | | | | |
cranes, electric orair driven hoists, specialty equipment as catagorized under520CMR
| | | | | | | | | | | |
| 6.00
20. incedent: A situation that results in serious injury, property damage or any
| | | | | | | | | | |
condition that is necessary for the preservation of the public health or safety
| | | | | | | | | | | | |
21. Injury and incedent documentation: A form furnished by the department de-
| | | | | | | | | |
tailing all specific info regarding any serious injury, property damage or mechanical
| | | | | | | | | | | |
failure that may have occurred
| | | | |
22. inspector: A District Engineering Inspector employed by the Department | | | | | | | |
23. Manufacturer approved attachment: Attachable equipment tailored to performa | | | | | | | |
| particular task, designed or approved for use in accordance with the equipment
| | | | | | | | | | |
4 |/ |23
