G2 Gas Technician Module 10 UPDATED ACTUAL Exam Questions and CORRECT Answers

G2 Gas Technician Module 10 UPDATED
ACTUAL Exam Questions and CORRECT
Answers
The working pressure differential between the gas meter outlet and the appliance regulator inlet
at furthest appliance from meter - CORRECT ANSWER - Define pressure drop



0.5" w.c. - CORRECT ANSWER - What is the Max pressure drop >7" w.c. NG



1" w.c. - CORRECT ANSWER - What is the Max pressure drop 7" - 14" w.c. NG


After piping system is installed and before any appliance is connected to it. - CORRECT
ANSWER - When do you do a high pressure test?



1. Isolate the piping system - CORRECT ANSWER -



2. Cap or plug open ends - CORRECT ANSWER -



3. Insert a pressure gauge at one end of the system - CORRECT ANSWER -


4. Pressurize system with air or inert gas to specified test pressure. - CORRECT
ANSWER - How do you do a High pressure test


1. High pressure test prior to connecting appliance. Disconnect piping at gas meter and before
appliance valve train. - CORRECT ANSWER -


2. Leak test with meter and appliance connected under normal operating pressure. Use a
manometer or lowest volume test dial on meter. 10 min duration - CORRECT ANSWER -

, 3. Leak test using a liquid solution under normal operating pressure. Check all fittings. -
CORRECT ANSWER -


4. Can also check system with manometer in an existing system which measure in. of W.C. this
is for systems up to 14" W.C. - CORRECT ANSWER - Three tests required by code when
installing


1. 3" in diameter - CORRECT ANSWER -


2. Max range shall exceed test pressure by at least 15% but less then 300% - CORRECT
ANSWER -


3. Pressure gauge shall read in increments of 2psig or 2% of maximum dial reading of pressure
gauge. Whichever is less. - CORRECT ANSWER - High pressure test gauges must be:



Annex H - CORRECT ANSWER - Purging practices are located in which Annex?



The break point pointing on the same side as the appliance - CORRECT ANSWER -
Manual shut off valves shall be installed with?


Outdoor use only. - CORRECT ANSWER - What location can you install a #3.16 manual
shut off valve?


1. Type of fuel - CORRECT ANSWER -



2. Supply pressure - CORRECT ANSWER -



3. Type of material - CORRECT ANSWER -