DOD DRIVER / OPERATOR AERIAL FINAL EXAM STUDY GUIDE 2025/2026 COMPLETE QUESTIONS WITH CORRECT DETAILED ANSWERS || 100% GUARANTEED PASS <RECENT VERSION>

DOD DRIVER / OPERATOR AERIAL FINAL EXAM STUDY GUIDE 2025/2026 COMPLETE QUESTIONS WITH CORRECT DETAILED ANSWERS || 100% GUARANTEED PASS &lt;RECENT VERSION&gt; 1. The Aerial ladder is the most common type of aerial apparatus operated in North America? True or False - ANSWER True 2. Aerial ladders are primarily used for? - ANSWER Ventilation, rescue, elevated master stream application, and gaining access to upper levels of an emergency scene. 3. Includes the pre-piped aerial ladder waterway, detachable ladder pipe system, elevating waterway system, and the water tower system - ANSWER water delivery system 4. Extends the third, fourth, and fifth sections of the aerial device - ANSWER cable system 5. Includes the electrical power generation equipment, scene lighting, and hydraulic extrication tool systems - ANSWER mounted special system 6. Provides power for operating the various components needed to stabilize the apparatus and extend the aerial device - ANSWER Hydraulic system 7. During a tandem pumping operation make sure you do not - ANSWER exceed the rated pressure of the hose or pump 8. If you have to draft from a static water source, try to select the source that allows - ANSWER minimum amount of lift 9. During relay pumping operating, the intake pressure relief valves are used to - ANSWER reduce the potential for damage to the pump or hoselines 10. Identify a true statement about preliminary checks - ANSWER ensure that the wheels are properly chocked to prevent rolling, if required 11. When the stabilizers have made contact with the ground, the driver/operator should - ANSWER alternate between the sides to raise the vehicle to its working condition 12. During the lowering procedure of an aerial device, it is best to drain the waterway system - ANSWER before any movement of the aerial device 13. When raising the aerial device, extend the fly sections of the aerial device until - ANSWER the tip of the device is slightly above the target 14. Elevated platforms are good devices for rescuing victims but are not recommended for - ANSWER mass rescues from one location 15. In window rescues, most fire departments prefer to position the aerial platform so the - ANSWER top rail is even with the windowstill 16. Identify two true statements about foam streams operated from elevated master streams - ANSWER non-aerated foam has fast knock-down but doesn't form a blanket over the fuel one acceptable foam concentrate is aqueous film forming foam (AFFF) 17. Name two things a responder should remember when ventilating an upper story window from an aerial device - ANSWER ensure responders below stay clear position the aerial device slightly above the upwind side of the window 18. When not in use, an adjustable nozzle should be set to the - ANSWER fog position 19. Water delivery systems do what? - ANSWER Discharge elevated master streams for fire attack from the aerial device 20. A ladder's base is best described as - ANSWER the bottom section of the aerial ladder 21. Identify three factors that influence your ability to maintain control over an aerial apparatus - ANSWER centrifugal force skidding speed 22. The key thing to remember when conducting an inspection of an aerial apparatus is to - ANSWER be systematic 23. When working with hydraulic extrication tools, driver/operators should wear - ANSWER safety gloves 24. Identify 2 aerial apparatus systems that are used for the extension of the aerial device - ANSWER cable hydraulic 25. Identify 3 service test for aerial appartus - ANSWER pressure control test priming test pumping test 26. The driver/operator will often be required to perform what test - ANSWER Service test 27. When do you perform the vacuum test - ANSWER after the engine speed check 28. Tracking engine performance over time requires data collected in the _ record - ANSWER fuel, oil, and mileage record 29. Identify 4 skills demonstrated during the alley dock exercise - ANSWER interpreting spotter signals using side mirrors operating the aerial apparatus safely moving the apparatus backward within a restricted area 30. Identify which factor is optional during the diminishing clearance exercise stopping at a finish line speed using a spotter(s) Traveling backward - ANSWER speed 31. When working near overhead lines, aerial apparatus driver/operators should try to maintain a distance of at least - ANSWER 10 feet (3m) 32. Identify 3 indicators that a building may become unstable - ANSWER falling bricks interior collapse sagging roofs 33. If possible whe positioning near a railroad, keep the apparatus at least _ feet. - ANSWER 25 feet from the tracks 34. During relay pumping operations, the intake pressure relief valves are used to what? - ANSWER reduce the potential for damage to the pumper or hoselines 35. When drafting from a static water source it is important to remember to - ANSWER make your connections before moving into position 36. Identify 2 features that provides automatic locking capabilities on most aerial apparatus - ANSWER holding valves and interlock 37. When parked with the aerial device in its stowed position, an aerial apparatus has a what - ANSWER base of stability limited to the rectangle formed at each corner by the tires 38. To provide hydraulic power to the stabilization system: - ANSWER move the selector valve to the stabilization 39. When working with parapet-style roofs, the most effective aerial device for rescues may be the - ANSWER three-section articulating device 40. To minimize the risk to responders, nozzles on detachable waterways should be operated - ANSWER with ropes attached to the nozzle 41. When protecting exposures using a solid stream: - ANSWER never direct elevated streams into natural ventilation openings 42. Identify 3 conditions where you should drive an aerial apparatus in low gear - ANSWER climbing a hill traveling around a corner approaching an intersection 43. The type of water delivery system on an aerial device specifically designed for the deployment of elevated master streams is a - ANSWER elevating water tower system 44. The gauge and flow meter test compares flow meter readings with - ANSWER tank-to-pump flow rate 45. Identify 3 critical items that should be included on an aerial apparatus daily record - ANSWER lubricant level inspected by column tire inflation pressure 46. Any fire fighter climbing the aerial ladder or occupying the tip or platform of an aerial should wear and use a ladder belt meeting the requirements of: - ANSWER NFPA 1983 47. At a minimum, how often should a certified emergency vehicle technician perform a detailed inspection of the apparatus and aerial device? - ANSWER Every year 48. At what distance from its desired position should a driver/operator place an aerial device before turning over control to a fire fighter at the tip or platform? - ANSWER 10 feet (3m) 49. For most one-and two family private dwellings, placement of the apparatus will usually be: - ANSWER Front and center relative to the structure 50. How should the driver/operator approach a victim's location with the tip or platform of the aerial device? - ANSWER Upwind and above the victim's location 51. In situations where the ladder on the tiller apparatus must be rotated at a low angle of inclination to stay below electrical wires, what is the distance from the building for the apparatus to be placed? - ANSWER 25-30 feet (8-9m) 52. What is installed in newer tiller apparatus to prevent the driver/operator from starting the apparatus and driving off without a tiller operator? - ANSWER Dead man's switch 53. When making a right-hand turn at an intersection, in which position does the tiller operator turn the wheels? - ANSWER Left at the beginning of the turn, then right halfway through the turn until in-line with the tractor 54. When it is necessary to operate an aerial device in high wind conditions, the driver/operator should spot the apparatus in a manner that: - ANSWER minimizes the extension needed. 55. When spotting an apparatus at a structural fire incident, driver/operators should be the MOST aware of: - ANSWER falling debris. 56. If an apparatus is to be positioned in a dead-end access, it should be backed into position if possible because it will: - ANSWER make an escape faster if it becomes necessary. 57. At a railroad incident, even after it has been confirmed with the railroad company that train traffic has been halted on that set of tracks, the aerial apparatus should: - ANSWER be kept at least 25 ft. (7.5 m) above the level of the rails. 58. When responding to hazardous materials incidents, which is the BEST reason the aerial apparatus should not be parked over manholes or storm drains? - ANSWER Flammable material flowing into the underground system could ignite and explode. 59. Which will help position the apparatus in a safe location that maximizes its capabilities at a technical rescue incident? - ANSWER Maintaining adequate distance from any unstable terrain 60. Whenever possible, the driver/operator should avoid _____ by getting as close to the desired objective as safely possible. - ANSWER long extensions at low angles 61. When would be the BEST time to develop apparatus placement procedures involving access to occupancies and overhead obstructions? - ANSWER During preincident planning 62. Which term refers to positioning the apparatus in a location that provides the utmost efficiency for operating on the fireground? - ANSWER Spotting 63. If the building has been exposed to severe fire conditions, it is advisable to park: - ANSWER outside of the building's collapse zone. 64. By positioning the truck body in line with the expected position of aerial use, the stability of the apparatus: - ANSWER can be increased. 65. If multiple apparatus must work on a bridge, they should not be parked on the same span because: - ANSWER the combined static load may exceed the bridge's design limitations. 66. When possible, driver/operators should always approach incidents from: - ANSWER upwind and uphill. 67. Which is the BEST potential sign of structural collapse that may be identified from an overhead look on an aerial device at a structural incident? - ANSWER Bulging walls 68. When positioning an apparatus with the rear uphill on a grade, which tactical impact should be considered? - ANSWER It will be easier to reach the ground with a platform operating off the rear. 69. When responding to an incident at a highway, the fire apparatus should be positioned at an angle to: - ANSWER act as a shield between the flow of traffic and firefighters working at the incident. 70. Why is it important to stay away from a downed power line with both feet on the ground at the same time? - ANSWER It will prevent you from becoming a conductor between two areas that are charged differently. 71. When jackknifing an apparatus, the greatest stability occurs when the angle is approximately: - ANSWER 60 degrees. 72. The MOST common consideration when spotting an aerial apparatus in cold weather is the: - ANSWER presence of ice and snow on the parking surfaces. 73. Why may parking lots be as dangerous as soft soil when spotting apparatus? - ANSWER They have thin-skinned paved surfaces that do not provide a stable base. 74. What is MOST crucial to the success of protecting a petroleum storage/processing facility? - ANSWER Preincident planning and training sessions between industrial and municipal firefighters 75. During nighttime roadway incidents, the minimum number of warning lights should be used because it: - ANSWER prevents blinding or distracting other drivers. 76. One visual indicator of a compromised asphalt surface due to extreme heat is: - ANSWER asphalt that "bleeds" creating a shiny, glass-like surface. 77. The distance between the objective and the aerial apparatus should be: - ANSWER consistent with conditions at the emergency scene. 78. For operations spotting an aerial apparatus in windy conditions, the driver/operator should always adhere to: - ANSWER the manufacturer's recommendations. 79. What may cause dry, solid ground to become unstable during warm weather operations? - ANSWER Fireground runoff 80. When should the driver/operator park on a soft surface? - ANSWER Only as a last alternative 81. When must driver/operators must follow departmental SOPs for positioning at the fire scene? - ANSWER On every response 82. Which is a factor that works against an aerial device's strength? - ANSWER Stresses 83. Which situation increases stress on an aerial device? - ANSWER When the apparatus is parked on an incline and the aerial device must be operated off of the side of the apparatus 84. Which of the following is clearance that should be maintained between working firefighters and high-voltage transmission lines over 50,000 volts? - ANSWER 50 ft. (15 m) 85. During an emergency medical incident, how should the driver/operator position the apparatus if it is not possible to locate off the street? - ANSWER Should position apparatus to shield firefighters from traffic 86. NFPA 1901 - ANSWER Standard for Fire Apparatus 87. NFPA 1911 - ANSWER Standard for Fire Apparatus Maintenance 88. NFPA 1002 - ANSWER Standard for Driver Operator professional Qualifications 89. NFPA 1451 - ANSWER Standard for Fire Service Vehicle Training Program 90. NFPA 1989 - ANSWER Standard for Breathing Air Requirements 91. Caution should be exercised around normally harmless overhead wires such as telephone and cable TV lines because: - ANSWER they may be in contact with electric lines somewhere down the line and be energized. 92. When driving an apparatus during inclement weather, the driver should: - ANSWER turn off auxiliary brake. 93. Where is the secondary control position for the aerial operator? - ANSWER At the tip or in the platform 94. A trained and authorized aerial operator MUST staff the _____ any time the aerial is in operation. - ANSWER primary controls 95. What results when the floor of the platform and/or the knuckle between booms are not parallel to the ground? - ANSWER A twisting force on the entire aerial device system 96. Raising the telescoping aerial device means which of the following? - ANSWER Elevating the entire assembly from its stored position to a desired angle and useful position 97. Which command would MOST likely be used to instruct the driver/operator to rotate the device? - ANSWER Rotate clockwise 98. Which should the driver/operator consult to determine if the device can be deployed safely below grade? - ANSWER Manufacturer's operating guide 99. Firefighters should never hold onto the ladder hand rails, rungs, or lacing while: - ANSWER extending the ladder. 100. When pinnable waterways are operated in the rescue mode, the master stream nozzle is: - ANSWER one aerial section lower than the tip. 101. Which type of apparatus is preferred when placing one or more firefighters at the position where the elevated master stream is going to be deployed? - ANSWER Elevating platform