Period 1 RS-03 Boilermaker Hand tools
Of all the clamps on the market, the _____ clamp is the most widely used by
boilermakers – answer C
Sockets are classified by size according to two factors, the ______ and the size of nut
or bolt it fits - answer Drive size
There are three standard American pattern metal file cuts; they are the single cut,
double cut, and _______ cut - answer Curved
One of the most common faults when using a ballpeen is ______ - answer Holding the
handle too close to the head
When cutting thin sections of metal with a hacksaw, a _____ tooth blade is the best -
answer Fine
There are three basic classifications of files: mill, machinists, and ______ pattern -
answer Swiss
Adjustable wrenches (crescent wrenches) are not for _______ nuts and bolts -
answerHard to turn
The ______ chisel is used for cutting V-grooves (such as those in a boiler tube) that is
to be removed from a sheet - answerDiamond point
A Stillson pipe wrench should never be used for_______ - answerNuts and bolts
Six and eight point box wrenches are used for _____ duty work - answerHeavy
Regular _____ point sockets are designed expressly for square nut and bolt heads -
answer4 and 8
Taps are used for ______ - answerCutting internal threads
Three major types of tooth sets used with hacksaw blades are alternate set, raker set,
and ____ set - answerWavy
The type of drift pin that has equal tapers at both ends is the _____ pin - answerBarrel
Tools such as chisels which are struck by hammers should have the heads ground
periodically to prevent _____ - answerMushrooming
Of all the clamps on the market, the _____ clamp is the most widely used by
boilermakers – answer C
Sockets are classified by size according to two factors, the ______ and the size of nut
or bolt it fits - answer Drive size
There are three standard American pattern metal file cuts; they are the single cut,
double cut, and _______ cut - answer Curved
One of the most common faults when using a ballpeen is ______ - answer Holding the
handle too close to the head
When cutting thin sections of metal with a hacksaw, a _____ tooth blade is the best -
answer Fine
There are three basic classifications of files: mill, machinists, and ______ pattern -
answer Swiss
Adjustable wrenches (crescent wrenches) are not for _______ nuts and bolts -
answerHard to turn
The ______ chisel is used for cutting V-grooves (such as those in a boiler tube) that is
to be removed from a sheet - answerDiamond point
A Stillson pipe wrench should never be used for_______ - answerNuts and bolts
Six and eight point box wrenches are used for _____ duty work - answerHeavy
Regular _____ point sockets are designed expressly for square nut and bolt heads -
answer4 and 8
Taps are used for ______ - answerCutting internal threads
Three major types of tooth sets used with hacksaw blades are alternate set, raker set,
and ____ set - answerWavy
The type of drift pin that has equal tapers at both ends is the _____ pin - answerBarrel
Tools such as chisels which are struck by hammers should have the heads ground
periodically to prevent _____ - answerMushrooming
