How much air is needed to burn a gallon of fuel oil and why
Give this one a try later!
14.4 plus 50% 192 feet cubed 154 CF to ensure enough oxygen
In a burner that has been properly set up and adjusted it will experience and
occasional hard start of puff back the problem Maybe
,Give this one a try later!
Low voltage input to the Transformer
What is the minimum distance that the burner can be from the tank
Give this one a try later!
5 feet
Can stack switches be used as a primary control
Give this one a try later!
Yes
What effect would cut down on excess air have on co2 percentage
Give this one a try later!
It would increase CO2 readings
How high on the wall should thermostat be installed
Give this one a try later!
, 5 feet from the ground
What is the greatest loss in a boiler
Give this one a try later!
Heat loss through the chimney
when using a blank heater it is necessary to maintain sufficient boiling water
temperature to heat the domestic hot water
Give this one a try later!
Tankless heater
Before using an electronic analyzer you must
Give this one a try later!
Performers smoke test to be sure you're bringing at 0 to trace of smoke
How is an oil burner wired
Give this one a try later!
, Shall be wired on its own circuit. All protective control and emergency
devices shall be series connected in the grounded line conductors. all the
electrical wiring shall be in accordance with 527 CMR 12.00 Massachusetts
electrical code
it is becoming more and more of a problem to get enough air to the burner because.
Give this one a try later!
less air gets into modern buildings because of new construction standards.
better Windows and Doors .more insulation and weatherstripping.
What are the four no heat call steps
Give this one a try later!
#1Oil check#2 fuse breaker#3 emergency switch#4 power
How long can flexible conduit be on an oil burner
Give this one a try later!
6 feet
a layer of Ash 1/16 inch thick will increase fuel consumption by
Give this one a try later!
14.4 plus 50% 192 feet cubed 154 CF to ensure enough oxygen
In a burner that has been properly set up and adjusted it will experience and
occasional hard start of puff back the problem Maybe
,Give this one a try later!
Low voltage input to the Transformer
What is the minimum distance that the burner can be from the tank
Give this one a try later!
5 feet
Can stack switches be used as a primary control
Give this one a try later!
Yes
What effect would cut down on excess air have on co2 percentage
Give this one a try later!
It would increase CO2 readings
How high on the wall should thermostat be installed
Give this one a try later!
, 5 feet from the ground
What is the greatest loss in a boiler
Give this one a try later!
Heat loss through the chimney
when using a blank heater it is necessary to maintain sufficient boiling water
temperature to heat the domestic hot water
Give this one a try later!
Tankless heater
Before using an electronic analyzer you must
Give this one a try later!
Performers smoke test to be sure you're bringing at 0 to trace of smoke
How is an oil burner wired
Give this one a try later!
, Shall be wired on its own circuit. All protective control and emergency
devices shall be series connected in the grounded line conductors. all the
electrical wiring shall be in accordance with 527 CMR 12.00 Massachusetts
electrical code
it is becoming more and more of a problem to get enough air to the burner because.
Give this one a try later!
less air gets into modern buildings because of new construction standards.
better Windows and Doors .more insulation and weatherstripping.
What are the four no heat call steps
Give this one a try later!
#1Oil check#2 fuse breaker#3 emergency switch#4 power
How long can flexible conduit be on an oil burner
Give this one a try later!
6 feet
a layer of Ash 1/16 inch thick will increase fuel consumption by
