STRUCTURED|100% PASS
QUESTIONS ANSWERS
2) Why high pressure gas pump (HPG)
automatically stop running after running To prevent the system from overheating
continuously for 10 minutes?
3) The transaxle receives power from the
and transfers it to the front Transmission
and rear wheels.
5) Explain in your own words the advan-
Provides a quicker stop time and more
tage of air over hydraulic brake from a
reliability
standard braking system.
1- black out switch
2- headlights and clearance lights
6) lighting MUX panel 3- internal dome light selector
4-Dome light Dimmer
5- Dash light dimmer
7) List five High Pressure Gas (HPG) Operational, Loading, Tie Down, Ford-
Suspension Settings the DRIVER uses. ing, and SAES
A) Drains the batteries to the point where
the vehicle can't be started
How does using the Combat Override B) Disables neutral safety start
switch affect the JLTV? Select all that C) Bypasses all speed interlocks and
apply system de-rates
D) Ties the batteries together for more
amperage
An emergency Ingress tool which is used
9) What tool is shown below and what is
to open the door in the event of a casualty
its purpose?
or rollover
10) What do you do if an item in the Basic
Annotate it on the BII Inventory and call
issue item (BII) appears to be unservice-
Field Maintenance
able?
11) What is the lowest temperature you
should use the the Arctic kit when start- -40° F
ing a vehicle?
12) On which variant is the spare tire CCWC
located at the rear of the vehicle? Select HGC
all that apply. GP
1/5
, JLTV PRACTICE QUESTIONS AND ANSWERS 2025|WELL
STRUCTURED|100% PASS
QUESTIONS ANSWERS
Damage, leaks: fluids, oil, and water lev-
13) List five pre-checks items you inspect
el; engine warm-up; instruments; safety
before driving the JLTV?
devices; tools and equipment
The suspension lock-out braces prevent
14) Why must you install suspension
the suspension from lowering as that
lock-out braces before crawling under
would crush the personnel underneath
the vehicle?
the vehicle
15) While conducting PMCS, you notice
the transmission fluid has a small leak
It is a Class 1 leak, so you can operate
but it is not big enough to form a drop.
the vehicle
Classify and decide if you operate the
vehicle.
17) When exiting the JLTV, which direc- Facing the JLTV so if you fall, your back
tion should the driver be facing and why? hits the ground instead of your face
18) Braking while cornering will make the
Push
JLTV have a tendency to .
19) You are navigating a left-hand turn
at a high rate of speed when you feel
your cargo weight shifting to the right Release the throttle and gently steer into
side of your vehicle. What actions should the direction of the weight transfer
you take to regain your center of gravity
through the turn?
20) You are approaching a 4-way stop.
No. Because the driver does not have a
Without the aid of your A-driver, do you
clear field view to the right side of the
have adequate field of view to safety nav-
vehicle.
igate a left-hand turn? Why or why not?
21) Location, terrain conditions, gross
weight of the disabled vehicle, and the Rolling resistance
mire level all contribute to the .
22) what recovery options are available if Like-vehicle recovery
your JLTV exceeds a mire level 1? Select Seek additional recovery assistance or
all that apply. follow unit SOP procedures
23) which of the following conditions con-
A JLTV mired at the fender
stitutes Mire level 2?
Attempt drive out of the mire
2/5