pipe fitter test |40 Complete
Questions and Answers
What does TE in TE-601 stand for? - -temperature element
- what does B.T.U stand for? - -British Thermal Unit
- what is the boiling point of water? - -212*F
- What is 3.1416? - -Pi
- what is the circumference of a 15" pipe? (to the nearest tenth0 - -47"
- 4" in the hundredths of a foot is? - -.33
- what is the take off for a 4" x 3" LR reducing 90* ell? - -6"
- on isometric drawings what does RFWN mean? - -raised face weld neck
- what does the Pi in Pi-209 stand for? - -pressure indicator
- 101.25' converted into inches is what? - -101'-3"
- if testing the shell side of an exchanger with the flat cap removed and all
the tubes on the bottom row had a steady flow of water pouring out of them,
this would indicate: - -floating head gasket leaking
- 3/4" is equal to? - -6/8
- the lap joint flange is usually used when_______? - -flange hold alignment is
a problem
- what is the number of a square feet in the surface of a steel plate 180
inches high and 48 inches wide? - -60 square feet
- what device is installed between a control valve and the air supply header?
- -regulator
- what is the most common degree of bevel on a pipe to be butt welded? - -
37 1/2
- the three states of matter are: - -solids, liquids,and gases
Questions and Answers
What does TE in TE-601 stand for? - -temperature element
- what does B.T.U stand for? - -British Thermal Unit
- what is the boiling point of water? - -212*F
- What is 3.1416? - -Pi
- what is the circumference of a 15" pipe? (to the nearest tenth0 - -47"
- 4" in the hundredths of a foot is? - -.33
- what is the take off for a 4" x 3" LR reducing 90* ell? - -6"
- on isometric drawings what does RFWN mean? - -raised face weld neck
- what does the Pi in Pi-209 stand for? - -pressure indicator
- 101.25' converted into inches is what? - -101'-3"
- if testing the shell side of an exchanger with the flat cap removed and all
the tubes on the bottom row had a steady flow of water pouring out of them,
this would indicate: - -floating head gasket leaking
- 3/4" is equal to? - -6/8
- the lap joint flange is usually used when_______? - -flange hold alignment is
a problem
- what is the number of a square feet in the surface of a steel plate 180
inches high and 48 inches wide? - -60 square feet
- what device is installed between a control valve and the air supply header?
- -regulator
- what is the most common degree of bevel on a pipe to be butt welded? - -
37 1/2
- the three states of matter are: - -solids, liquids,and gases
