SACA 201 Silver Actual Exam Questions &
Answers Latest Update
Practice questions for this set
2
4
Terms in this set (85)
A(n) ______ is used to measure resistance. Ohmmeter
What is the total measurement of voltage Applied Voltage
over the power source called?
Rotary motion is the output of which Motor
electrical output device?
Current is measured in units of ______ _. Amps
What step should be taken to correctly Disconnect one end of the resistor
measure the resistance of a resistor that is
wired in a circuit?
, The resistance provided by an inductor in Inductive reactance
an AC circuit is called ___ _.
What does hertz stand for on a sine wave Cycles per second
graph?
What is the total inductance of a series 0.9 Henrys
circuit if the power supply frequency is 60
Hz and 3 coils each have an inductance
of 0.3 henrys?
A common application of mutual Transformer
inductance is found in a device called a
__________.
What is the secondary voltage if the 200 VAC
primary is 480VAC? (The primary coil
have 300 turns and the secondary coil
has 125 turns)*
Which of the following is not a Insulator
component of a basic electrical circuit?
What is the thin insulator placed between Dielectric
the plates of a capacitor called?
One of the effects a capacitor has in a DC Charge to a voltage equal to the source voltage
circuit is that it will ___ _.
Capacitance is measured in _____ _. Farads
What is a drawing showing electrical Schematic
symbols and paths?
Current in a(n)_______ circuit is divided Parallel
among the branches of the circuit.
When the wire or foil strip inside a fuse Blown
melts, the fuse is said to be _ _.
The potential difference between two Voltage
points in a circuit is called ____.
To measure current through a In series with
component, the ammeter must be
connected_______ the component.
What creates an electric field and stores Capacitor
electricity?
What should you do before working on Preform a lockout/tagout
electrical equipment?
What type of transformer is used to get 2:1 with center tap
two 60 volt lines from a 240 volt source?
What creates a magnetic field and stores Inductor
energy?
The minimum requirement for a complete a power source, load, and wires to connect it all
electric circuit is a path that has
The Ohm's Law formula for calculating E=I×R
voltage is ____ _.
The amount of voltage that is used by Resistance
each load depends on the ____ of
each load.
Answers Latest Update
Practice questions for this set
2
4
Terms in this set (85)
A(n) ______ is used to measure resistance. Ohmmeter
What is the total measurement of voltage Applied Voltage
over the power source called?
Rotary motion is the output of which Motor
electrical output device?
Current is measured in units of ______ _. Amps
What step should be taken to correctly Disconnect one end of the resistor
measure the resistance of a resistor that is
wired in a circuit?
, The resistance provided by an inductor in Inductive reactance
an AC circuit is called ___ _.
What does hertz stand for on a sine wave Cycles per second
graph?
What is the total inductance of a series 0.9 Henrys
circuit if the power supply frequency is 60
Hz and 3 coils each have an inductance
of 0.3 henrys?
A common application of mutual Transformer
inductance is found in a device called a
__________.
What is the secondary voltage if the 200 VAC
primary is 480VAC? (The primary coil
have 300 turns and the secondary coil
has 125 turns)*
Which of the following is not a Insulator
component of a basic electrical circuit?
What is the thin insulator placed between Dielectric
the plates of a capacitor called?
One of the effects a capacitor has in a DC Charge to a voltage equal to the source voltage
circuit is that it will ___ _.
Capacitance is measured in _____ _. Farads
What is a drawing showing electrical Schematic
symbols and paths?
Current in a(n)_______ circuit is divided Parallel
among the branches of the circuit.
When the wire or foil strip inside a fuse Blown
melts, the fuse is said to be _ _.
The potential difference between two Voltage
points in a circuit is called ____.
To measure current through a In series with
component, the ammeter must be
connected_______ the component.
What creates an electric field and stores Capacitor
electricity?
What should you do before working on Preform a lockout/tagout
electrical equipment?
What type of transformer is used to get 2:1 with center tap
two 60 volt lines from a 240 volt source?
What creates a magnetic field and stores Inductor
energy?
The minimum requirement for a complete a power source, load, and wires to connect it all
electric circuit is a path that has
The Ohm's Law formula for calculating E=I×R
voltage is ____ _.
The amount of voltage that is used by Resistance
each load depends on the ____ of
each load.
