CPCS A40 Slinger Signaller Exam
Questions and Answers 100% Pass
Before being guided by a signaller for a pick and carry duty, what instruction should
be given to the machine operator by the signaller if they lose sight of each other? -
✔✔Stop until the signaller is back in sight of the crane operator (line of sight)
Only two legs of a 6 tonne four-leg chain sling are being used. In principle, what is the
maximum load that can be lifted with that sling? - ✔✔3 tonnes
During inspections, damage has been found to a lifting accessory. What TWO actions
must be taken? - ✔✔1 - Remove from service
2 - Report to lift supervisor and clearly mark as unusable
If attaching accessories to a quick-hitch coupler, give TWO reasons why the coupler
should be tilted in the downwards position (ram extended)? - ✔✔1- The accessory will
be failing on the coupler
2- It would cause restrictive movement, causing bending and twisting to the accessory
How can a qualification or card benefit a slinger/signaller? - ✔✔Proof of skill
100% Pass Guarantee Katelyn Whitman, All Rights Reserved © 2025 1
,What TWO things should be considered when selecting a place of refuge or safety
within a designated plant manoeuvring area? - ✔✔1 - Easy access
2- Well protected (barriers and signs)
If setting up to lift loads in a pedestrianised area, state ONE factor that needs to be
taken into account by the slinger/signaller. - ✔✔Barriers to prevent any overhead lifts
a) What does the date working load (SWL), as stamped on lifting accessories, indicate?
b) What action should be taken if the SWL is not marked on a lifting accessory? - ✔✔a)
The maximum lifting capacity in a particular configuration
b) Accessory can't be used
During the lifting operation, part of the task cannot be carried out as detailed in the lift
plan.
a) What initially must happen to the lifting operation?
b) Who authorises any changes? - ✔✔a) Stop until the method statement is amended
b) Only Appointment Person (AP)
What is regarded as the danger or hazard zone during a lifting operation? - ✔✔Full
working radios of the machine
a) When is a trial lift carried out?
100% Pass Guarantee Katelyn Whitman, All Rights Reserved © 2025 2
, b) Name 4 checks to be made? - ✔✔a) Every time you do a lift
b) Weight, level, fully supported, sling attached properly
On the lifting capacity diagram chart within Section A40:
a) What is the type of sling shown in item B?
b) What is type of hitch shown? - ✔✔a) Flat web sling
b) Single choke hitch
The slinger has to use new lifting accessories that they are unfamiliar with. What do
Regulations (e.g. LOLER 98) and other guidance require the slinger/signaller to have? -
✔✔I - Information
I - Instructions
T - Training
Travelling with extra-long loads can be more hazardous for what reason? - ✔✔Loads
can turn or swing
Loads can hit buildings, machines or structures
Give TWO examples of where The Work at Height Regulations may apply to lifting
operations - ✔✔1- Work off a lorry bed or trailer
2- Taken accessories of a top of load
100% Pass Guarantee Katelyn Whitman, All Rights Reserved © 2025 3
Questions and Answers 100% Pass
Before being guided by a signaller for a pick and carry duty, what instruction should
be given to the machine operator by the signaller if they lose sight of each other? -
✔✔Stop until the signaller is back in sight of the crane operator (line of sight)
Only two legs of a 6 tonne four-leg chain sling are being used. In principle, what is the
maximum load that can be lifted with that sling? - ✔✔3 tonnes
During inspections, damage has been found to a lifting accessory. What TWO actions
must be taken? - ✔✔1 - Remove from service
2 - Report to lift supervisor and clearly mark as unusable
If attaching accessories to a quick-hitch coupler, give TWO reasons why the coupler
should be tilted in the downwards position (ram extended)? - ✔✔1- The accessory will
be failing on the coupler
2- It would cause restrictive movement, causing bending and twisting to the accessory
How can a qualification or card benefit a slinger/signaller? - ✔✔Proof of skill
100% Pass Guarantee Katelyn Whitman, All Rights Reserved © 2025 1
,What TWO things should be considered when selecting a place of refuge or safety
within a designated plant manoeuvring area? - ✔✔1 - Easy access
2- Well protected (barriers and signs)
If setting up to lift loads in a pedestrianised area, state ONE factor that needs to be
taken into account by the slinger/signaller. - ✔✔Barriers to prevent any overhead lifts
a) What does the date working load (SWL), as stamped on lifting accessories, indicate?
b) What action should be taken if the SWL is not marked on a lifting accessory? - ✔✔a)
The maximum lifting capacity in a particular configuration
b) Accessory can't be used
During the lifting operation, part of the task cannot be carried out as detailed in the lift
plan.
a) What initially must happen to the lifting operation?
b) Who authorises any changes? - ✔✔a) Stop until the method statement is amended
b) Only Appointment Person (AP)
What is regarded as the danger or hazard zone during a lifting operation? - ✔✔Full
working radios of the machine
a) When is a trial lift carried out?
100% Pass Guarantee Katelyn Whitman, All Rights Reserved © 2025 2
, b) Name 4 checks to be made? - ✔✔a) Every time you do a lift
b) Weight, level, fully supported, sling attached properly
On the lifting capacity diagram chart within Section A40:
a) What is the type of sling shown in item B?
b) What is type of hitch shown? - ✔✔a) Flat web sling
b) Single choke hitch
The slinger has to use new lifting accessories that they are unfamiliar with. What do
Regulations (e.g. LOLER 98) and other guidance require the slinger/signaller to have? -
✔✔I - Information
I - Instructions
T - Training
Travelling with extra-long loads can be more hazardous for what reason? - ✔✔Loads
can turn or swing
Loads can hit buildings, machines or structures
Give TWO examples of where The Work at Height Regulations may apply to lifting
operations - ✔✔1- Work off a lorry bed or trailer
2- Taken accessories of a top of load
100% Pass Guarantee Katelyn Whitman, All Rights Reserved © 2025 3
