OSHA Exam Questions and Answers 100% Pass

OSHA Exam Questions and Answers 100% Pass What test should be performed on abrasive wheels? - Ring test Compressed air can be used for cleaning as long as it is less than 30 psi. - True All _______ that are designed to accommodate guards must be equipped with properly functioning guards when in use - Power operated tools Appropriate switches for belt sanders are - Momentary contact on/off switches Jointers should be fitted with which of the following types of guards - Point of operation guards Impact tools, such as chisels, with _____ heads should be removed from use. - Mushroom Most tools that run on liquid fuel are powered by - Gasoline Powder-actuated tools should never be used on ________ materials - All of the above 2100% Pass Guarantee Katelyn Whitman, All Rights Reserved © 2025 Jacks must be inspected: - All of the above Fixed, power-driven woodworking tools are not required to be provided with a disconnect switch that can either be locked or tagged in the off position. - False Employers can exceed safe load limits for floors as long as it is temporary and no longer than 10 days - Which of the following is not a general requirement for safe material storage? 7 - The maximum height of a stack of bricks is _____ feet. Tiers - All materials stored in _____ must be stacked, racked, blocked, interlocked or otherwise secured to prevent sliding, falling or collapse. All of the abvove - Accumulated materials in storage area could cause: frequency of activity - Material handling tasks should be designed to minimize weight, range of motion and ______. If the load is too bulky to grasp or lift - Employees should seek help lifting which of the following? In fire-resistant covered containers - Solvent waste, oily rags and flammable liquids must be kept: False - General requirements do not apply to slings used in conjunction with other material handling equipment for the movement of material by hosting. 3100% Pass Guarantee Katelyn Whitman, All Rights Reserved © 2025 Laid synthetic fiber rope - In _____, eye splices must contain at least four full tucks and short splices must contain at least eight full tucks (four on each side of the center line of the splice). True - Higher safe working loads are permissible when recommended by the manufacturer for specific, identifiable products, provided that a safety factor of not less than 5 is maintained. Prior to use on each shift - Rigging equipment for material handling must be inspected: False - Attachments such as shop hooks, makeshift fasteners or rods may be used on steel chain slings based on the manufacturer's approval. Use blocking or padding to increase the radius of the bend - The best way to prevent wire rope failure due to the development of small cracks is to: Wet frozen sling - The temperature range for the unsafe use of natural and synthetic rope slings is -20 F to 180 F except for: True - Polypropylene web slings may be used at temperatures higher than that of natural fiber slings. centered on the forks and as close to the mast as possible - Loads on forklifts must be _____. 4100% Pass Guarantee Katelyn Whitman, All Rights Reserved © 2025 False - To offset an overload, extra weight should be placed on the rear of the forklift. False - Modifications may be made to cranes at the discretion of the employer locked out - In this case study, the Lockout/Tagout standard would require that the crane be secured from movement, and that hydraulic or pneumatic lines that could be come energized be _____. True - If the employee had referred to his employer's lockout/tagout procedure checklist, the likelihood of the employee's survival would have increased. Both A and B - Which of the Skid-Steer Loader' safety systems were disabled, resulting in 100 injuries and fatalities All of the above - Which of the following is a safety feature required in all earthmoving equipment? Employee health screenings - Which of the following is not one of the four main elements of an effective occupational safety and health program? True - Training should emphasize factors that