©THESTAR 2024/2025 ALL RIGHTS RESERVED 11:04PM.
IAAI CFI Study Exam Questions And
Answers 2025 Update.
Combustible Liquid - Answer✔A liquid with a flash point ABOVE 100F
12.5 - Answer✔If the current flowing out from an electrical panel is 12.5 amps, and it then
flows through an electrical load of 1500 watts, what is the amperage of the remaining current
flow of the return circuit?
1000 - Answer✔If a hair dryer draws 8.3amps (in a home with 120-volt service), what is the
wattage?
*Power (P) = current (I) x voltage (V)
Watts = amps x volts
1987 - Answer✔The year of the first edition of NFPA 1033
1.5 times - Answer✔The recommended distance for securing the perimeter of a blast scene
*That is, the distance from the furthest debris
1100°F - Answer✔What temperature in the upper gas layer causes the onset of Flashover?
1960°F - Answer✔The temperature at which copper melts
2 W/cm2 - Answer✔The measurement of the radiant heat flux (from gas layer to the floor) that
indicates the onset of flashover
240 volts - Answer✔The voltage between the two hot wires at the service entrance cables in
most single-family residences in the United States (single-phase service with three wires)
3 years - Answer✔The revision cycle for NFPA 921 (timespan)
350°F - Answer✔The flash point of power steering fluid
1
,©THESTAR 2024/2025 ALL RIGHTS RESERVED 11:04PM.
35-70 p.s.i. - Answer✔In high-pressure fuel-injected vehicles, this is the typical range of
pressure that is used to pump fuel from a fuel tank
5 and 17 - Answer✔The lower explosive and upper explosive limit of natural gas (methane)?
680°F - Answer✔The ignition temperature of power steering fluid
Fuel - Answer✔Any substance that can undergo combustion
Act or Omission - Answer✔Two factors or situations leading to a fire that may show the nature
of the incident responsibility.
Additional Investigative Recommendations - Answer✔This concept should not be included in a
summary report of findings.
Admiralty Law - Answer✔A law that may govern the fire investigation of a boat
After-market Equipment - Answer✔A type of device in a vehicle, which can cause an electrical
overload to factory installed wiring
Alive and Breathing - Answer✔Evidence of smoke or soot in the lungs, bronchi, and trachea is
one of the most significant factors in confirming that, at the time of the fire, the victim was
WHAT?
All Team Members - Answer✔Those who have the responsibility for monitoring safety
conditions at the fire or explosion scene
1220°F - Answer✔The melting temperature of aluminum
Aluminum-to-pavement sparks - Answer✔Which one of these is NOT considered a competent
ignition source?
Metal-to-metal sparks,
Aluminum-to-pavement sparks,
Metal-to-pavement sparks,
Motor bearing sparks
Heat Release Rate - Answer✔A meaningful analysis of a fire requires an understanding of the
fire growth, the total heat released, and WHAT?
Arc-fault circuit interrupter - Answer✔What does he term AFCI stand for? And, the "A"
specifically represents what?
ASTM - Answer✔The organization that develops standard methods for testing materials
Auto-ignition - Answer✔Initiation of combustion by heat but without a spark or flame
2
, ©THESTAR 2024/2025 ALL RIGHTS RESERVED 11:04PM.
Backdraft - Answer✔A deflagration resulting from the sudden introduction of air into a
confined space containing oxygen-deficient products of incomplete combustion
Backdraft - Answer✔An explosion caused by a combination of combustible materials heated to
the ignition point and a sudden introduction of oxygen to support combustion
Backfire Flame Arrestor - Answer✔A boat device that owners fail to keep clean, which is a
frequent cause of engine compartment fires on boats
Ballast - Answer✔A device on a fluorescent light fixture that transforms the voltage from
normal household voltage to a higher voltage
Battery - Answer✔The starter motor draws its energy from this source
Beyond a Reasonable Doubt - Answer✔The burden of proof in a criminal trial
Bimetallic Thermostats - Answer✔The component that controls temperature in many heat-
producing appliances
BLEVE - Answer✔This may occur when the vapor pressure of a liquid exceeds atmospheric
pressure
*And this is the most common mechanical explosion
Boiling Point - Answer✔The temperature or point at which the vapor pressure of a liquid equals
the external pressure applied
Bonding - Answer✔The process of electrically connecting two or more conductive objects
Bottom Passenger Side of the Windshield - Answer✔Most engine fires typically penetrate the
interior compartment at this location of the vehicle
Brass Prongs (male ends) - Answer✔An investigator can closely examine this component of a
cord to determine if it was plugged into a receptacle
Calcination - Answer✔The chemical and physical changes that occur in gypsum wallboard
surfaces during a fire
Carbon Monoxide - Answer✔A narcotic gas that one might be exposed to in the fire
Carbon Monoxide - Answer✔The levels of this toxin dissipate over time after removal from the
fire environment.
Carbon Monoxide Poisoning - Answer✔This toxic condition does NOT cause a cherry-pink
coloration to the skin of the fire victim and is NOT visible on all skin types
Carburetor Backfire - Answer✔This occurrence is the most common open-flame ignition source
in non-fuel injected vehicles
3
IAAI CFI Study Exam Questions And
Answers 2025 Update.
Combustible Liquid - Answer✔A liquid with a flash point ABOVE 100F
12.5 - Answer✔If the current flowing out from an electrical panel is 12.5 amps, and it then
flows through an electrical load of 1500 watts, what is the amperage of the remaining current
flow of the return circuit?
1000 - Answer✔If a hair dryer draws 8.3amps (in a home with 120-volt service), what is the
wattage?
*Power (P) = current (I) x voltage (V)
Watts = amps x volts
1987 - Answer✔The year of the first edition of NFPA 1033
1.5 times - Answer✔The recommended distance for securing the perimeter of a blast scene
*That is, the distance from the furthest debris
1100°F - Answer✔What temperature in the upper gas layer causes the onset of Flashover?
1960°F - Answer✔The temperature at which copper melts
2 W/cm2 - Answer✔The measurement of the radiant heat flux (from gas layer to the floor) that
indicates the onset of flashover
240 volts - Answer✔The voltage between the two hot wires at the service entrance cables in
most single-family residences in the United States (single-phase service with three wires)
3 years - Answer✔The revision cycle for NFPA 921 (timespan)
350°F - Answer✔The flash point of power steering fluid
1
,©THESTAR 2024/2025 ALL RIGHTS RESERVED 11:04PM.
35-70 p.s.i. - Answer✔In high-pressure fuel-injected vehicles, this is the typical range of
pressure that is used to pump fuel from a fuel tank
5 and 17 - Answer✔The lower explosive and upper explosive limit of natural gas (methane)?
680°F - Answer✔The ignition temperature of power steering fluid
Fuel - Answer✔Any substance that can undergo combustion
Act or Omission - Answer✔Two factors or situations leading to a fire that may show the nature
of the incident responsibility.
Additional Investigative Recommendations - Answer✔This concept should not be included in a
summary report of findings.
Admiralty Law - Answer✔A law that may govern the fire investigation of a boat
After-market Equipment - Answer✔A type of device in a vehicle, which can cause an electrical
overload to factory installed wiring
Alive and Breathing - Answer✔Evidence of smoke or soot in the lungs, bronchi, and trachea is
one of the most significant factors in confirming that, at the time of the fire, the victim was
WHAT?
All Team Members - Answer✔Those who have the responsibility for monitoring safety
conditions at the fire or explosion scene
1220°F - Answer✔The melting temperature of aluminum
Aluminum-to-pavement sparks - Answer✔Which one of these is NOT considered a competent
ignition source?
Metal-to-metal sparks,
Aluminum-to-pavement sparks,
Metal-to-pavement sparks,
Motor bearing sparks
Heat Release Rate - Answer✔A meaningful analysis of a fire requires an understanding of the
fire growth, the total heat released, and WHAT?
Arc-fault circuit interrupter - Answer✔What does he term AFCI stand for? And, the "A"
specifically represents what?
ASTM - Answer✔The organization that develops standard methods for testing materials
Auto-ignition - Answer✔Initiation of combustion by heat but without a spark or flame
2
, ©THESTAR 2024/2025 ALL RIGHTS RESERVED 11:04PM.
Backdraft - Answer✔A deflagration resulting from the sudden introduction of air into a
confined space containing oxygen-deficient products of incomplete combustion
Backdraft - Answer✔An explosion caused by a combination of combustible materials heated to
the ignition point and a sudden introduction of oxygen to support combustion
Backfire Flame Arrestor - Answer✔A boat device that owners fail to keep clean, which is a
frequent cause of engine compartment fires on boats
Ballast - Answer✔A device on a fluorescent light fixture that transforms the voltage from
normal household voltage to a higher voltage
Battery - Answer✔The starter motor draws its energy from this source
Beyond a Reasonable Doubt - Answer✔The burden of proof in a criminal trial
Bimetallic Thermostats - Answer✔The component that controls temperature in many heat-
producing appliances
BLEVE - Answer✔This may occur when the vapor pressure of a liquid exceeds atmospheric
pressure
*And this is the most common mechanical explosion
Boiling Point - Answer✔The temperature or point at which the vapor pressure of a liquid equals
the external pressure applied
Bonding - Answer✔The process of electrically connecting two or more conductive objects
Bottom Passenger Side of the Windshield - Answer✔Most engine fires typically penetrate the
interior compartment at this location of the vehicle
Brass Prongs (male ends) - Answer✔An investigator can closely examine this component of a
cord to determine if it was plugged into a receptacle
Calcination - Answer✔The chemical and physical changes that occur in gypsum wallboard
surfaces during a fire
Carbon Monoxide - Answer✔A narcotic gas that one might be exposed to in the fire
Carbon Monoxide - Answer✔The levels of this toxin dissipate over time after removal from the
fire environment.
Carbon Monoxide Poisoning - Answer✔This toxic condition does NOT cause a cherry-pink
coloration to the skin of the fire victim and is NOT visible on all skin types
Carburetor Backfire - Answer✔This occurrence is the most common open-flame ignition source
in non-fuel injected vehicles
3
