ABYC Electrical Exam (2025) comprehensive
questions and verified detailed solutions (
MULTIPLE CHOICES) |100% CORRECT!!
Save
Terms in this set (87)
Which tool is most
approprite to clean
battery connections?
A.
B.
C.
D.
The minimum amp circuit A. 15
breaker that should be
used to protect 120V
water heater circuit with a
1600-watt element would
be rated at _________ amps.
A. 15
B. 10
C. 20
D. 30
https://quizlet.com/1012734308/abyc-electrical-exam-2025-comprehensive-questions-and-verified-detailed-solutions-multiple-choices-100-correc… 1/29
,3/2/25, 4:58 PM ABYC Electrical Exam (2025) comprehensive questions and verified detailed solutions ( MULTIPLE CHOICES) |100% CORRE…
When testing for C. Gauss meter
excessive EMF emissions
near a conductor or
appliance, the tool of
choice is a(an):
A. Ohmmeter
B. DVOM
C. Gauss meter
D. infrared sensor
The primary problem A. voltage drop across each load will be excessive
with using a series circuit
to supply multiple loads
is that:
A. voltage drop will be
excessive
B. the capacitance will be
excessive
C. amperage draw will be
multiplied
D. the overcurrent
protection device may
not work
The most common C. unwanted open
electrical circuit problem
in a marine application is:
A. short circuits
B. too much continuity
C. unwanted open
D. intercircuit short
The primary by-product D. heat
of excessive electrical
resistance is:
A. increased amperage
B. increased voltage
C. reduced ambient
temperature
D. heat
https://quizlet.com/1012734308/abyc-electrical-exam-2025-comprehensive-questions-and-verified-detailed-solutions-multiple-choices-100-correc… 2/29
, 3/2/25, 4:58 PM ABYC Electrical Exam (2025) comprehensive questions and verified detailed solutions ( MULTIPLE CHOICES) |100% CORRE…
One horsepower equals B. 746 watts
______.
A. 1000 watts
B. 746 watts
C. 536 watts
D. 146 watts
Excessive electrical D. undersized wire, loose connections, and
resistance can be caused corrosion.
by __________.
A. oversized conductors,
loose terminals, and
corrosion.
B. improper wire
insulation and excessive
wire strand count.
C. fuses with too high of
a rating and wattage that
is too low.
D. undersized wire, loose
connections, and
corrosion.
The tool of choice for D. TDR
tracing shorted and open
circuits is the:
A. Megohmeter
B. Amp clamp
C. potential meter
D. TDR
https://quizlet.com/1012734308/abyc-electrical-exam-2025-comprehensive-questions-and-verified-detailed-solutions-multiple-choices-100-correc… 3/29