NATIONAL ELECTRIC CODE FINAL EXAM AND PRACTICE EXAM | COMPLETE 2025 ACTUAL EXAM WITH CORRECT VERIFIED ANSWERS | GUARANTEED A+ EXAM EXCELLENCE

NATIONAL ELECTRIC CODE FINAL EXAM AND

PRACTICE EXAM | COMPLETE 2025 ACTUAL EXAM

WITH CORRECT VERIFIED ANSWERS |

GUARANTEED A+ EXAM EXCELLENCE



What is the maximum number of bends allowed in one run conduit,

between outlet and outlet fitting and fitting, or fitting and outlet.

A. 1 quarter bend (90 degrees)

B. 6 quarter bends (540 degrees)

C. 4 quarter bends (360 degrees)

D. 2 quarter bends (180 degrees) C. 4 quarter bends

,The frame grounding conductor in a DC trailing cable is usually colored:

A. Green

B. Black

C. White

D. Red A. Green




"Grounded conductors" (not in the frame ground) will be identified be

their color, which is:

A. Green or green with one or more yellow stripes

B. Black

C. White or natural gray

D. Red

E. Green C. White or natural grays

,The voltage drop to the most remote outlet of a branch circuit should

not exceed what value for power, heating, lightning, or combinations

there of?

A. 3%

B. 2%

C. 10%

D. 6% A. 3%




What is the purpose of a thermal strip in an AC line starter?

A. To provide overcurrent protection

B. To provide short circuit protection

C. To provide over voltage protection

, D. To prevent moisture from accumulating in the starting box A. To

provide overcurrent protection




In most cases, the voltage to ground on branch circuits supplying lamp

holders, fixtures, or standard receptacles of 15 amps or less should not

exceed:

A. 110 Volts

B. 150 Volts

C. 220 Volts

D. 117 Volts B. 150 Volts




If a branch circuit were provided by a 20 amp fuse, what would be the

allowable continuous load of the circuit?

A. 24 amps

B. 25 amps