Gas Welding and cutting OSHA Exam Questions and Answers 100% Pass

Gas Welding and cutting OSHA Exam Questions and Answers 100% Pass During transporting moving and storing compressed gas cylinders valve protection caps - Shall be in place and secured When cylinders are hoisted - They shall not Be secured on cradles Sling board or pallet they shall not be hoisted or transported by means of magnets or choker Sling's Cylinders shall be moved by - tilting and rolling them on their bottom edges, they shall not be intentionally dropped, struck, or permitted to strike each other violently when cylinders are transported by powered vehicles - They shall be secured in a vertical position Valve protection caps shall not be used for - lifting cylinders from one vertical position to another, bars shall not be used under valves or valve protection caps to pry cylinders loose when frozen, warm, not boiling water shall be use to thaw cylinders loose 2100% Pass Guarantee Sophia Bennett, All Rights Reserved © 2025 unless cylinders are firmly secured on a special carrier intended for this purpose - regulators shall be removed and valve protection caps put in place before cylinders are moved a suitable cylinder truck, chains, or other steadying devices - shall be used to keep cylinders from being knocked over while in use when work is finished, when cylinders are empty, or when cylinders are moved at any time the cylinder valve - shall be closed compressed gas cylinders - shall be secured in an upright position at all times except, if necessary, for short periods of time while cylinders are actually being hoisted or carried oxygen cylinders in storage shall be - separated from fuel-gas cylinders or combustible materials (specially oil or grease), a min distance of 20 feet or by non- combustible barrier at least 5 feet high having a fire-resistance rating of at least one-half hour inside of buildings, cylinders shall be stored - in a well protected, ventilated, dry location, at least 20ft from highly combustible materials such as oil excelsior. Cylinders should be stored in definitely assigned places away from elevators, stairs, or gangway. Assigned storage places shall be located where cylinders will not be knocked over or 3100% Pass Guarantee Sophia Bennett, All Rights Reserved © 2025 damaged by passing or falling objects, or subject to tampering by unauthorized persons. Cylinders shall not be kept in unventilated enclosures such as lockers and cupboards the in plant handling, storage, and utilization of all compressed gases in cylinders, portable tanks, rail track cars or motor vehicle cargo tanks - shall be in accordance with Compressed Gas Association Pamphlet P-1-1965 cylinders shall be kept far enough away from the actual welding or cutting operation to prevent - sparks, hot slag, or flame reaching them, when this is impractical, fire resistant shields shall be provided Cylinder distance from electrical circuit - should be placed far enough away at to not become part of electrical circuit. Electrodes shall not be struck against a cylinder to strike an arc fuel gas cylinders shall be placed - with valve end up whenev