Stationary Engineer Exam UPDATED
ACTUAL Exam Questions and CORRECT
Answers
High pressure steam boilers generally operate at pressures
A. above 15 psi and over 6 boiler horsepower.
B. below 15 psi and over 8 boiler horsepower.
C. above 250 psi and over 6 boiler horsepower.
D. at 212 psi and over 8 boiler horsepower. - CORRECT ANSWER - A. above 15 psi and
over 6 boiler horsepower.
Pressure gauges should never have a range less than
A. half the safety valve set pressure.
B. double the safety valve set pressure.
C. 3/4 times the safety valve set pressure.
D. 1 1/2 times the safety valve set pressure. - CORRECT ANSWER - D. 1 1/2 times the
safety valve set pressure.
After water is blown out of a siphon, why should live steam never be allowed to enter a Bourdon
tube?
A. The steam will rupture the siphon tube.
B. Combustion gases will mix with the steam.
C. Live steam will damage the pressure gauge.
D. The water level gauge will be damaged or destroyed. - CORRECT ANSWER - C. Live
steam will damage the pressure gauge.
All of the following are essential to maintain the proper fuel oil pressure with fuel oil accessories
EXCEPT
A. achieving the right flow of fuel.
,B. proper atomization of the fuel oil.
C. heating fuel oil to the correct temperature.
D. obtaining the correct difference in pressure inside and outside the boiler. - CORRECT
ANSWER - D. obtaining the correct difference in pressure inside and outside the boiler.
Which of the following could be dangerous to safe operation of a low pressure boiler?
A. Adding water to an operating boiler when the water level cannot be seen in the gauge glass
tube.
B. Opening the blowdown valve at the bottom of the water gauge glass before making a water
level reading.
C. Checking the water level using the try cocks valves when the line to the glass gauge tube is
clogged.
D. Opening the water column blowdown valve every day. - CORRECT ANSWER - A.
Adding water to an operating boiler when the water level cannot be seen in the gauge glass tube.
Which of the following is best if a low-pressure boiler does not have an air vent?
A. Vent the boiler with the try cocks.
B. Vent the boiler with the safety valve.
C. Vent the boiler with the fusible plug.
D. Vent the boiler with the blowdown line. - CORRECT ANSWER - A. Vent the boiler
with the try cocks.
What is the purpose of an evaporation test on a low pressure boiler?
A. To test the water column
B. To test the bottom blowdown valve
C. To test the steam pressure safety valve
D. To test the low water cutoff control. - CORRECT ANSWER - D. To test the low water
cutoff control.
Following flame failure, controls must de-energize fuel and ignition circuits
, A. within 4 seconds.
B. within 6 seconds.
C. within 10 seconds.
D. within 15 seconds. - CORRECT ANSWER - A. within 4 seconds.
How can an operator prevent damage to the tubes while using a cleaner to remove scale from
boiler tubes?
A. Never use a chemical cleaning procedure.
B. Never use cleaning water under pressure.
C. Never allow the cleaner to stay in one place.
D. Never clean the tubes more often than every six months. - CORRECT ANSWER - C.
Never allow the cleaner to stay in one place.
In a steam boiler, which of the following should never be placed between the safety relief valve
and the boiler?
A. A steam trap
B. A shut-off valve
C. An air eliminator
D. A discharge pipe - CORRECT ANSWER - B. A shut-off valve
Which of these should be used on live electrical fires?
A. Class D extinguishers
B. Class C extinguishers
C. Class B extinguishers
D. Class A extinguishers - CORRECT ANSWER - B. Class C extinguishers
If certain grades of fuel oil are not preheated properly, they may cause
A. higher temperatures in the furnace.
B. back pressure and leaks in the fuel lines.
ACTUAL Exam Questions and CORRECT
Answers
High pressure steam boilers generally operate at pressures
A. above 15 psi and over 6 boiler horsepower.
B. below 15 psi and over 8 boiler horsepower.
C. above 250 psi and over 6 boiler horsepower.
D. at 212 psi and over 8 boiler horsepower. - CORRECT ANSWER - A. above 15 psi and
over 6 boiler horsepower.
Pressure gauges should never have a range less than
A. half the safety valve set pressure.
B. double the safety valve set pressure.
C. 3/4 times the safety valve set pressure.
D. 1 1/2 times the safety valve set pressure. - CORRECT ANSWER - D. 1 1/2 times the
safety valve set pressure.
After water is blown out of a siphon, why should live steam never be allowed to enter a Bourdon
tube?
A. The steam will rupture the siphon tube.
B. Combustion gases will mix with the steam.
C. Live steam will damage the pressure gauge.
D. The water level gauge will be damaged or destroyed. - CORRECT ANSWER - C. Live
steam will damage the pressure gauge.
All of the following are essential to maintain the proper fuel oil pressure with fuel oil accessories
EXCEPT
A. achieving the right flow of fuel.
,B. proper atomization of the fuel oil.
C. heating fuel oil to the correct temperature.
D. obtaining the correct difference in pressure inside and outside the boiler. - CORRECT
ANSWER - D. obtaining the correct difference in pressure inside and outside the boiler.
Which of the following could be dangerous to safe operation of a low pressure boiler?
A. Adding water to an operating boiler when the water level cannot be seen in the gauge glass
tube.
B. Opening the blowdown valve at the bottom of the water gauge glass before making a water
level reading.
C. Checking the water level using the try cocks valves when the line to the glass gauge tube is
clogged.
D. Opening the water column blowdown valve every day. - CORRECT ANSWER - A.
Adding water to an operating boiler when the water level cannot be seen in the gauge glass tube.
Which of the following is best if a low-pressure boiler does not have an air vent?
A. Vent the boiler with the try cocks.
B. Vent the boiler with the safety valve.
C. Vent the boiler with the fusible plug.
D. Vent the boiler with the blowdown line. - CORRECT ANSWER - A. Vent the boiler
with the try cocks.
What is the purpose of an evaporation test on a low pressure boiler?
A. To test the water column
B. To test the bottom blowdown valve
C. To test the steam pressure safety valve
D. To test the low water cutoff control. - CORRECT ANSWER - D. To test the low water
cutoff control.
Following flame failure, controls must de-energize fuel and ignition circuits
, A. within 4 seconds.
B. within 6 seconds.
C. within 10 seconds.
D. within 15 seconds. - CORRECT ANSWER - A. within 4 seconds.
How can an operator prevent damage to the tubes while using a cleaner to remove scale from
boiler tubes?
A. Never use a chemical cleaning procedure.
B. Never use cleaning water under pressure.
C. Never allow the cleaner to stay in one place.
D. Never clean the tubes more often than every six months. - CORRECT ANSWER - C.
Never allow the cleaner to stay in one place.
In a steam boiler, which of the following should never be placed between the safety relief valve
and the boiler?
A. A steam trap
B. A shut-off valve
C. An air eliminator
D. A discharge pipe - CORRECT ANSWER - B. A shut-off valve
Which of these should be used on live electrical fires?
A. Class D extinguishers
B. Class C extinguishers
C. Class B extinguishers
D. Class A extinguishers - CORRECT ANSWER - B. Class C extinguishers
If certain grades of fuel oil are not preheated properly, they may cause
A. higher temperatures in the furnace.
B. back pressure and leaks in the fuel lines.
