100% Pass
1. In a single anchor bendix drum type rear brake: the secondary lining is longer than the pri
c c c c c c c c c c c c c c c c
mary
2. Compared to the secondary shoe lining areas of drum brakes, the primary shoe lining
c c c c c c c c c c c c c c
area is:: smaller and goes toward the front of the car
c c c c c c c c c c
3. During a brake overhaul, you notice that the brake fluid seems to be very dirty and da
c c c c c c c c c c c c c c c c
rk in color. What should you do?: flush the system before the new parts are installed
c c c c c c c c c c c c c c c
4. In order to bleed the system on a vehicle equipped with power brakes:: None of the above
c c c c c c c c c c c c c c c c
5. Which of the following could be a symptom of over-
c c c c c c c c c
torqued lug nuts?: A brake pedal pulsation during braking.
c c c c c c c c
6. Which of the following describes the proper sequence to bleed brake lines on most rea
c c c c c c c c c c c c c c
r wheel drive vehicles:: RR, LR, RF, LF
c c c c c c c
7. In disc brake caliper assemblies, the "square cut seal" is usually located:: In the caliper p
c c c c c c c c c c c c c c c
iston bore c
8. When performing a caliper overhaul, what would you use to remove the pistons fro
c c c c c c c c c c c c c
m the calipers?: Compressed air
c c c c
9. Sliding caliper disc brake pads are kept in adjustment by the: Square cut piston seal
c c c c c c c c c c c c c c
10. A cracked or torn vacuum diaphragm in a power booster would likely cause:: Har
c c c c c c c c c c c c c
d pedal with very high effort required
c c c c c c
11. When the brakes are applied on a car with disc-
c c c c c c c c c
drum brakes, a vibration or pulsating movement is felt. What can cause this problem?: A ro
c c c c c c c c c c c c c c c
tor thickness variation
c c
12. While test driving a car, the mechanic finds that the right front brake "grabs". The mo
c c c c c c c c c c c c c c c
st likely cause of this problem is:: Brake fluid or grease on the brake linings.
c c c c c c c c c c c c c c
13. During a road test, you find that when normal breaking pressure is applied the pedal sl
c c c c c c c c c c c c c c c
owly goes to the floor. What is the likely cause of this problem?: A leaking master cylinder p
c c c c c c c c c c c c c c c c c
rimary piston seal. c c
1c/c
13
, 14. A rattle is a single piston disc brake assembly which goes away when the brakes are a
c c c c c c c c c c c c c c c c
pplied is most likely a result of:: Loose pads in the caliper
c c c c c c c c c c c
15. Which of the following would most likely cause dragging brakes?: A defec-
c c c c c c c c c c c
tive vehicle load sensor
c c c c
16. With the car standing still, you can hear a squeaking noise when applying the brake pe
c c c c c c c c c c c c c c c
dal slowly. What could cause this noise?: Dry backing plate contact surfaces.
c c c c c c c c c c c
2c/c
13