100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached 4.2 TrustPilot
logo-home
Exam (elaborations)

Automotive Electrical Basics Exam Questions and Answers 100% Pass

Rating
-
Sold
-
Pages
9
Grade
A+
Uploaded on
07-02-2025
Written in
2024/2025

Automotive Electrical Basics Exam Questions and Answers 100% Pass Short-To-Ground - If an insulated (power side) wire rubbed through a part of the insulation and the wire conductor touched the steel body of a vehicle, the type of failure would be called a(an) ________. Short-To-Voltage - If two insulated wires were to melt together where the copper conductors touched each other, the type of failure would be called a(an) ________. 4 amperes - If 12 volts are being applied to a resistance of 3 ohms, ________ amperes will flow. 14.4 Watts - How many watts are consumed by a light bulb if 1.2 amperes are measured when 12 volts are applied? 1500 Watts - How many watts are consumed by a starter motor if it draws 150 amperes at 10 volts? Slow motor operation, Dim lights and clicking of relay and solenoids - High resistance in a circuit can cause ________. 2Disclaimer: Original Content, No Copyright Infringement, All Rights Reserved © 2025 It increases - If the voltage increases in a circuit, what happens to the current (amperes) if the resistance stays the same? 200 Amperes - If 200 amperes flow from the positive terminal of a battery and operate the starter motor, how many amperes will flow back to the negative terminal of the battery? E - What is the symbol for voltage used in calculations? Short-To-Ground - Which circuit is failure is most likely to cause a fuse to blow? Continuity - A complete circuit that is continuous from source through loads and back to ground has ________. The vehicle frame & the metal body of the vehicle - The electrical path to ground may be completed by ________. May be on either the source or ground side of the circuit and control electrical flow in a circuit - Electrical controls such as switches ________

Show more Read less
Institution
Automotive Service
Course
Automotive Service









Whoops! We can’t load your doc right now. Try again or contact support.

Written for

Institution
Automotive Service
Course
Automotive Service

Document information

Uploaded on
February 7, 2025
Number of pages
9
Written in
2024/2025
Type
Exam (elaborations)
Contains
Questions & answers

Subjects

Content preview

Automotive Electrical Basics Exam
Questions and Answers 100% Pass


Short-To-Ground - ✔✔If an insulated (power side) wire rubbed through a part of the

insulation and the wire conductor touched the steel body of a vehicle, the type of failure

would be called a(an) ________.


Short-To-Voltage - ✔✔If two insulated wires were to melt together where the copper

conductors touched each other, the type of failure would be called a(an) ________.


4 amperes - ✔✔If 12 volts are being applied to a resistance of 3 ohms, ________ amperes

will flow.


14.4 Watts - ✔✔How many watts are consumed by a light bulb if 1.2 amperes are

measured when 12 volts are applied?


1500 Watts - ✔✔How many watts are consumed by a starter motor if it draws 150

amperes at 10 volts?


Slow motor operation, Dim lights and clicking of relay and solenoids - ✔✔High

resistance in a circuit can cause ________.




Disclaimer: Original Content, No Copyright Infringement, All Rights Reserved © 2025 1

, It increases - ✔✔If the voltage increases in a circuit, what happens to the current

(amperes) if the resistance stays the same?


200 Amperes - ✔✔If 200 amperes flow from the positive terminal of a battery and

operate the starter motor, how many amperes will flow back to the negative terminal of

the battery?


E - ✔✔What is the symbol for voltage used in calculations?


Short-To-Ground - ✔✔Which circuit is failure is most likely to cause a fuse to blow?


Continuity - ✔✔A complete circuit that is continuous from source through loads and

back to ground has ________.


The vehicle frame & the metal body of the vehicle - ✔✔The electrical path to ground

may be completed by ________.


May be on either the source or ground side of the circuit and control electrical flow in a

circuit - ✔✔Electrical controls such as switches ________.


May be caused by a blown fuse - ✔✔An open circuit ________.


No current will flow - ✔✔In an incomplete circuit ________.


Neither: It is ALWAYS because a blown fuse or includes an open circuit - ✔✔A shorted

circuit ________.




Disclaimer: Original Content, No Copyright Infringement, All Rights Reserved © 2025 2

Get to know the seller

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
BrittieDonald Howard Community College
View profile
Follow You need to be logged in order to follow users or courses
Sold
399
Member since
2 year
Number of followers
162
Documents
20443
Last sold
6 days ago
BrittieDonald Study Solutions.

Get Help in Your Due Online and Actual Exams, Assignments with Well Researched and Up-to date Study Materials for Guaranteed Success

3.4

83 reviews

5
35
4
13
3
7
2
5
1
23

Recently viewed by you

Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Frequently asked questions