AWS-CWI Part B Test 3 Questions and Answers 100% Pass

AWS-CWI Part B Test 3 Questions and Answers 100% Pass true or false weld sizes, links, and location of Welds shall conform to the requirements of the part B book of specifications - true According to the pressure piping clause, linear indications greater than 3/16 inch long are unacceptable. true or false - true on a pipeline what is the aggregate length of incomplete Fusion or IF that is considered a defect when the weld length is less than 12 inches - when it exceeds 8% of the weld length what is the abbreviation for cracks? - C A welder who qualifies on a butt weld with backing is qualified to a weld __________ - A weld that is going to be back gouged on the backside of the groove Weld and then back welded. A weld with a backing strip. A weld with a backing weld with deposited first. 2Brittie Donald, All Rights Reserved © 2025 failure of any portion of a single test weldment for performance qualification constitutes failure for - welders use in the test the welding procedure qualification record may be presented in which format? - tabular or written a weld in a Groove weld in a butt joint that is transverse to the direction of computed tensile stress in a statically loaded non tubular Connection in a structural steel application is allowed how much visible porosity? - none what should an inspector do if it is noted that the welder taking the test is not exhibiting the necessary skills? - Terminate the test at any stage that they demonstrate in competency For pipeline applications, a repair weld made at the backside of a Groove weld is called ___________? - back weld repair when is a double repair of a crack permitted? - never the test weld may be terminated at any stage if the necessary skills are not exhibited. True or false - true there is no maximum acceptance Criterion for visual inspection of fillet weld size. True or false otherwise specified - true unless otherwise specified 3Brittie Donald, All Rights Reserved © 2025 what is a structural element which transmits the primary tensile stress and whose sole failure would be catastrophic? - primary member a burn through or bt is defined as a portion of the root bead where excessive penetration has caused weld puddle to be blown into the pipe resulting in a _________ in the root bead of a single Groove weld - whole or depression the procedures and apparatus for fracture toughness testing shall conform to the requirements of _____________? - AWS B4.0 on a guided bend test, how much radiesse must the corners in the bend be prepared? - 1/8 of an inch maximum tack weld that have cracked shall be removed and re-welded. True or false - true what would be an acceptable condition for a cjp or Complete Joint penetration Groove weld under structural steel visual inspection criteria? - reinforcement 1/16 inch high on 1 inch material when it is not feasible to maintain preheat until the joint is Complete, Welding may be interrupted and the joint allowed to cool slowly provide a minimum of _________ inch thickness of weld is deposited for ________ % of the groove is filled, whichever is less. - 3/8 of an inch and 25% what is the abbreviation for radiographic testing? - RT