NICET 1 - Practice Fire Alarm
Systems Level I test
questions and answers 2025
According to NFPA 72, how often shall waterflow devices
be tested?
Annually
1 multiple choice option
A wall-mounted visible appliance is being installed in a
protected premises that has a height of 6.75 feet. In this
application, what is the maximum distance from the
ceiling that the appliance may be mounted?
12 inches
For a Class B circuit, where is the end-of-line resistor
located?
at the device physically farthest from the panel
3 multiple choice options
Click on the Exhibit button.Which one of the symbols
shown represents a heat detector?
C
On a peaked ceiling, projected beam-type smoke detectors
must be installed within which maximum distance from
the peak?
, 3 feet
Which one of the following is a parallel circuit?
a single heat detector
3 multiple choice options
According to OSHA, which electrical cord is safe to use?
one that is free of cuts
3 multiple choice options
In a conventional fire alarm system, which component
serves as a contact device that is normally open?
high- or low-air pressure switch
3 multiple choice options
Cables installed under a corrugated metal roof deck must
be located at least which minimum distance from the roof
deck?
1 1/2 inches (1.50)
After the fire alarm system installation has been
completed, at what interval should system smoke
detectors undergo functional testing, after the alarm
contractor has performed the acceptance test of the fire
alarm system?
Fire alarm cable will run exposed inside a building riser.
Which three types of cable are acceptable for this
installation? (Choose three.)
CMP
3 multiple choice options
Fasteners shall be driven into which material when
working with conduit?
Which tool is required for mounting conduit?
Systems Level I test
questions and answers 2025
According to NFPA 72, how often shall waterflow devices
be tested?
Annually
1 multiple choice option
A wall-mounted visible appliance is being installed in a
protected premises that has a height of 6.75 feet. In this
application, what is the maximum distance from the
ceiling that the appliance may be mounted?
12 inches
For a Class B circuit, where is the end-of-line resistor
located?
at the device physically farthest from the panel
3 multiple choice options
Click on the Exhibit button.Which one of the symbols
shown represents a heat detector?
C
On a peaked ceiling, projected beam-type smoke detectors
must be installed within which maximum distance from
the peak?
, 3 feet
Which one of the following is a parallel circuit?
a single heat detector
3 multiple choice options
According to OSHA, which electrical cord is safe to use?
one that is free of cuts
3 multiple choice options
In a conventional fire alarm system, which component
serves as a contact device that is normally open?
high- or low-air pressure switch
3 multiple choice options
Cables installed under a corrugated metal roof deck must
be located at least which minimum distance from the roof
deck?
1 1/2 inches (1.50)
After the fire alarm system installation has been
completed, at what interval should system smoke
detectors undergo functional testing, after the alarm
contractor has performed the acceptance test of the fire
alarm system?
Fire alarm cable will run exposed inside a building riser.
Which three types of cable are acceptable for this
installation? (Choose three.)
CMP
3 multiple choice options
Fasteners shall be driven into which material when
working with conduit?
Which tool is required for mounting conduit?
