1
SKYWEST PREFLIGHT EXAM ACTUAL EXAM LATEST
UPDATE COMPLETE QUESTIONS AND CORRECT
ANSWERS ALREADY GRADED A+
MCD - (answer)All CRJs: verify pins aren't protruding
ERJ:
1. Lining cover is present.
2. Lock/vent flap lever (labeled "vent flap") is up
3. Escape slide lever (labeled "arming lever") is up
4. Escape slide indicator is disarmed.
5. Girt bar indicator is clear.
6. Lock indicators are clear.
7. Escape slide pressure gauge needle is in the green zone.
8. Caution strap is stowed
APU Serv Bus - (answer)CRJ 200 Only (FA Panel): verify APU service button is
off
Cabin and entry lights - (answer)All CRJs (FA panel): verify lights are
operational and test BRT, DIM, and OFF settings for each (ceiling, sidewall,
galley, dome, and boarding)
ERJ (FWD FA Panel):
Test BRT, DIM, and OFF for ceiling, sidewall, FWD entrance, and FWD Galley
Area
LAV Smoke Detectors (FWD and AFT) - (answer)ERJ (FWD FA Panel):
1. Ensure lavatory is empty
, 2
2. Press FWD LAVATORY SMOKE TEST button
3. Listen for aural alarm from FWD lavatory
4. Look for orange flashing light on FA indicator panel closest to lavatory
5. Repeat these steps for AFT lavatory
Reading Lights (PSUs) - (answer)All CRJs (FA Panel): Press TEST, look down
length of cabin at PSUs, then press OFF
PSU Test - (answer)ERJ (FWD FA Panel):
1. Press TEST to view following items operable
-FA indicator panel
-PSU reading lights
-FA call lights
-Lavatory lights on BRT
-FA area indicator lights
-Lavatory occupied signs on bulkheads
Panel Lights - (answer)ERJ:
-Verify lights next to buttons on FA panel are operational
-Press and hold TEST button to view operable FA panel lights
Emergency Lights - (answer)CRJ 200 (FA Panel): Verify operational
1. Lift red guard, move switch to ON, and verify lights are operational in cabin:
- Aisle lights, ceiling pods, flood lights, and luminescent paths
2. Turn EMG lights off immediately after inspecting
SKYWEST PREFLIGHT EXAM ACTUAL EXAM LATEST
UPDATE COMPLETE QUESTIONS AND CORRECT
ANSWERS ALREADY GRADED A+
MCD - (answer)All CRJs: verify pins aren't protruding
ERJ:
1. Lining cover is present.
2. Lock/vent flap lever (labeled "vent flap") is up
3. Escape slide lever (labeled "arming lever") is up
4. Escape slide indicator is disarmed.
5. Girt bar indicator is clear.
6. Lock indicators are clear.
7. Escape slide pressure gauge needle is in the green zone.
8. Caution strap is stowed
APU Serv Bus - (answer)CRJ 200 Only (FA Panel): verify APU service button is
off
Cabin and entry lights - (answer)All CRJs (FA panel): verify lights are
operational and test BRT, DIM, and OFF settings for each (ceiling, sidewall,
galley, dome, and boarding)
ERJ (FWD FA Panel):
Test BRT, DIM, and OFF for ceiling, sidewall, FWD entrance, and FWD Galley
Area
LAV Smoke Detectors (FWD and AFT) - (answer)ERJ (FWD FA Panel):
1. Ensure lavatory is empty
, 2
2. Press FWD LAVATORY SMOKE TEST button
3. Listen for aural alarm from FWD lavatory
4. Look for orange flashing light on FA indicator panel closest to lavatory
5. Repeat these steps for AFT lavatory
Reading Lights (PSUs) - (answer)All CRJs (FA Panel): Press TEST, look down
length of cabin at PSUs, then press OFF
PSU Test - (answer)ERJ (FWD FA Panel):
1. Press TEST to view following items operable
-FA indicator panel
-PSU reading lights
-FA call lights
-Lavatory lights on BRT
-FA area indicator lights
-Lavatory occupied signs on bulkheads
Panel Lights - (answer)ERJ:
-Verify lights next to buttons on FA panel are operational
-Press and hold TEST button to view operable FA panel lights
Emergency Lights - (answer)CRJ 200 (FA Panel): Verify operational
1. Lift red guard, move switch to ON, and verify lights are operational in cabin:
- Aisle lights, ceiling pods, flood lights, and luminescent paths
2. Turn EMG lights off immediately after inspecting
