ASE A6 ELECTRICAL/ELECTRONIC SYSTEMS
EXAM 2025
An air bag system is being serviced, Technician A says to disconnect the yellow SRS connectors at the
front of the vehicle. Technician B says to disconnect and isolate the negative battery cable.
Who is right?
A. Technician A only
B. Technician B only
C. Both A and B
D. Neither A or B - Precise Answer ✔✔.B
Which of these should be used when soldering electrician wiring connections?
A. rosin core flux
B. acid core flux
C. sulfur core flux
D. none of the above - Precise Answer ✔✔.a
When testing computer-controlled systems, a digital multimeter should be used with an input
impedance of at least:
A. lOk ohms
B. lOOk ohms
C. 1 megohm
D. 10 megohms - Precise Answer ✔✔.d
When troubleshooting a slow drain on the battery, which if these diagnostic tools should be used?
,A. Ohmmeter
B. Ammeter
C. Voltmeter
D. Test fight - Precise Answer ✔✔.b
The condition of a lead-acid battery is being checked. Technician A says to use a galvanometer.
Technician B says to use a capacitive battery tester.
Who is right?
A. Technician A only
B. Technician B only
C. Both A and B
D. Neither A or B - Precise Answer ✔✔.b
While testing a starting circuit on a 5.7L V8 engine, the technician finds that the engine cranks slowly.
The
starter current draw is 90 amps, and the battery voltage while cranking is 11 volts. What should the
technician do next?
A. Check for voltage drop of the starter motor circuit.
B. Test the battery capacity.
C. Replace the starter motor, as a short Is indicated.
D. Determine the condition of the engine. - Precise Answer ✔✔.a
Technician A says that a noisy alternator could be caused by a bad diode. Technician B says that a noisy
alternator could be caused by a worn bearing.
Who is right?
A. Technician A only
, B. Technician B only
C. Both A and B
D. Neither A or B - Precise Answer ✔✔.c
The analog ohmmeter needle does not move when connected as shown above. (pg 82) This indicates
that the rotor winding is:
A. shorted
B. grounded
C. complete
D. open - Precise Answer ✔✔.d
A vehicle's tum signals flash too slowly. Technician A claims that the condition could be caused by a
faulty flasher. Technician B says that a bulb may be the wrong type.
Who is right?
A. Technician A only
B. Technician B only
C. Both A and B
D. Neither A or B - Precise Answer ✔✔.c
Technician A says a short circuit to ground in a circuit will decrease resistance. Technician B says a short
circuit will Increase current flow.
Who is right?
A. Technician A only
B. Technician B only
C. Both A and B
D. Neither A or B - Precise Answer ✔✔.c
EXAM 2025
An air bag system is being serviced, Technician A says to disconnect the yellow SRS connectors at the
front of the vehicle. Technician B says to disconnect and isolate the negative battery cable.
Who is right?
A. Technician A only
B. Technician B only
C. Both A and B
D. Neither A or B - Precise Answer ✔✔.B
Which of these should be used when soldering electrician wiring connections?
A. rosin core flux
B. acid core flux
C. sulfur core flux
D. none of the above - Precise Answer ✔✔.a
When testing computer-controlled systems, a digital multimeter should be used with an input
impedance of at least:
A. lOk ohms
B. lOOk ohms
C. 1 megohm
D. 10 megohms - Precise Answer ✔✔.d
When troubleshooting a slow drain on the battery, which if these diagnostic tools should be used?
,A. Ohmmeter
B. Ammeter
C. Voltmeter
D. Test fight - Precise Answer ✔✔.b
The condition of a lead-acid battery is being checked. Technician A says to use a galvanometer.
Technician B says to use a capacitive battery tester.
Who is right?
A. Technician A only
B. Technician B only
C. Both A and B
D. Neither A or B - Precise Answer ✔✔.b
While testing a starting circuit on a 5.7L V8 engine, the technician finds that the engine cranks slowly.
The
starter current draw is 90 amps, and the battery voltage while cranking is 11 volts. What should the
technician do next?
A. Check for voltage drop of the starter motor circuit.
B. Test the battery capacity.
C. Replace the starter motor, as a short Is indicated.
D. Determine the condition of the engine. - Precise Answer ✔✔.a
Technician A says that a noisy alternator could be caused by a bad diode. Technician B says that a noisy
alternator could be caused by a worn bearing.
Who is right?
A. Technician A only
, B. Technician B only
C. Both A and B
D. Neither A or B - Precise Answer ✔✔.c
The analog ohmmeter needle does not move when connected as shown above. (pg 82) This indicates
that the rotor winding is:
A. shorted
B. grounded
C. complete
D. open - Precise Answer ✔✔.d
A vehicle's tum signals flash too slowly. Technician A claims that the condition could be caused by a
faulty flasher. Technician B says that a bulb may be the wrong type.
Who is right?
A. Technician A only
B. Technician B only
C. Both A and B
D. Neither A or B - Precise Answer ✔✔.c
Technician A says a short circuit to ground in a circuit will decrease resistance. Technician B says a short
circuit will Increase current flow.
Who is right?
A. Technician A only
B. Technician B only
C. Both A and B
D. Neither A or B - Precise Answer ✔✔.c
