NCCER Module 3 Review Questions | Latest Version | 2024/2025 | Correct & Verified

NCCER Module 3 Review Questions | Latest Version | 2024/2025 | Correct & Verified What is the purpose of a coping saw? To make intricate curved cuts in wood, plastic, or metal. How do you prevent a drill from wandering off the mark? Use a center punch to create a guide point before drilling. Why is it important to tighten a file into its handle securely? To avoid the handle coming loose during use, which could cause injury. What is the correct way to hold a chisel while working? Hold the handle firmly with one hand and keep the other hand safely away from the blade path. How should you position a plane when not in use? Lay it on its side to avoid dulling the blade or damaging the work surface. 2 What is the purpose of a tin snip? To cut sheet metal and thin materials cleanly. How can you prevent a saw blade from binding during a cut? Use a steady motion, keep the blade straight, and ensure the material is supported. What is the purpose of a try square? To check and mark 90-degree angles on wood or other materials. How do you ensure safety when cutting with a miter box and saw? Secure the material firmly and keep your hands clear of the cutting area. What should you check before using an adjustable wrench? Ensure the jaw is properly adjusted to fit snugly on the fastener. Why is it important to clean a rasp after use? To remove debris from the teeth, which helps maintain its cutting efficiency. 3 How can you extend the life of a screwdriver? Use the correct type and size for the screw and avoid using it as a pry tool. What is the function of a chalk line? To create a straight, temporary guide line on a surface. How do you ensure accurate cuts with a circular saw? Mark the cut line clearly, secure the material, and use a guide if necessary. Why is it necessary to wear gloves when using pliers on sharp or jagged objects? To protect your hands from cuts and abrasions. What is the primary use of a spade bit? To drill large holes in wood quickly. How do you check for square corners with a framing square? Align the square with the edges and ensure both sides are flush with the tool.