IMSA Signs & Markings I With Complete
Solutions 100% Verified
Traffic marking paint shall be stored
in a tightly sealed container and well ventilated.
When should the pivot points and jack stands on a towable message board be greased?
Every three months
One evaluated management strategy for maintaining sign retro-reflectivity is to
Conduct nighttime visual inspections
Pavement markings shall be removed by
grinder
There are three classes of traffic signs.
Regulatory, warning, guide
Why would underground utilities be located?
to avoid personal injury or damage to public property
What colored marking would a utility locator use to indicate that a gas line may be
present?
Yellow
What colored marking would an IMSA signs & pavement markings technician 1 use to
,mark a proposed dig site?
White
what could be a possible cause of a sign that is hard to weed?
insufficient pressure on plotter needle
sign post shall be so constructed as to hold signs in a permanent position and resist
swaying in the wind
If a sign has been damaged by vandalism such as bullet holes, what can IMSA signs &
pavement markings technician 1 use to make the necessary repairs?
pressure sensitive adhesive sheeting
When applying a pressure sensitive vinyl legend to retro-reflective sheeting, what
application equipment should an IMSA signs & pavement markings technician 1 use to
ensure the proper adhesion?
a roller table
What is a breakaway sign support?
A sign support that can be run over by vehicles.
What product is applied to paint to make it retro-reflective during striping operations?
glass beads
What are the MINIMUM and MAXIMUM dimensions of a crosswalk markings?
6 inches & 24 inches (150 mm & 600 mm)
, If any striping or marking equipment is damaged or needs maintenance, who does the
IMSA signs & pavement markings technician 1 need to notify?
Signs & Markings Supervisor
What can the IMSA signs & pavement markings technician 1 do EFFECTIVELY to assist
an agency in defending against lawsuits and tort liability claims?
proper record keeping
Which of the following directions for a sign face is MOST LIKELY to produce the fastest
rate of degradation?
South
What color are on each side of a wrong way raised pavement marker?
White & Red
What MUST the surface condition be like before installing a pre-formed thermoplastic
pavement marking?
Clean, dust free, and dry
A raised pavement marker may be used next to a curved approach end of raised median
when they are
immediately adjacent
Light emitting diode (LED) units may be used individually within the legend or symbol of
an illuminated sign and
in the border of the sign
Equipment that is NOT greased properly can be expected to fail?
at the end of its useful life
Solutions 100% Verified
Traffic marking paint shall be stored
in a tightly sealed container and well ventilated.
When should the pivot points and jack stands on a towable message board be greased?
Every three months
One evaluated management strategy for maintaining sign retro-reflectivity is to
Conduct nighttime visual inspections
Pavement markings shall be removed by
grinder
There are three classes of traffic signs.
Regulatory, warning, guide
Why would underground utilities be located?
to avoid personal injury or damage to public property
What colored marking would a utility locator use to indicate that a gas line may be
present?
Yellow
What colored marking would an IMSA signs & pavement markings technician 1 use to
,mark a proposed dig site?
White
what could be a possible cause of a sign that is hard to weed?
insufficient pressure on plotter needle
sign post shall be so constructed as to hold signs in a permanent position and resist
swaying in the wind
If a sign has been damaged by vandalism such as bullet holes, what can IMSA signs &
pavement markings technician 1 use to make the necessary repairs?
pressure sensitive adhesive sheeting
When applying a pressure sensitive vinyl legend to retro-reflective sheeting, what
application equipment should an IMSA signs & pavement markings technician 1 use to
ensure the proper adhesion?
a roller table
What is a breakaway sign support?
A sign support that can be run over by vehicles.
What product is applied to paint to make it retro-reflective during striping operations?
glass beads
What are the MINIMUM and MAXIMUM dimensions of a crosswalk markings?
6 inches & 24 inches (150 mm & 600 mm)
, If any striping or marking equipment is damaged or needs maintenance, who does the
IMSA signs & pavement markings technician 1 need to notify?
Signs & Markings Supervisor
What can the IMSA signs & pavement markings technician 1 do EFFECTIVELY to assist
an agency in defending against lawsuits and tort liability claims?
proper record keeping
Which of the following directions for a sign face is MOST LIKELY to produce the fastest
rate of degradation?
South
What color are on each side of a wrong way raised pavement marker?
White & Red
What MUST the surface condition be like before installing a pre-formed thermoplastic
pavement marking?
Clean, dust free, and dry
A raised pavement marker may be used next to a curved approach end of raised median
when they are
immediately adjacent
Light emitting diode (LED) units may be used individually within the legend or symbol of
an illuminated sign and
in the border of the sign
Equipment that is NOT greased properly can be expected to fail?
at the end of its useful life
