FANUC HANDLING PRO LATEST UPDATE

Enabling the iPendant gives motion solely to whom? A. The PLC B. The Controller C. The Operator - CORRECT ANSWER C Assuming standard setup, if you jog the robot in World -Y, which direction will the TCP move? A. Straight out front B. Up C. To the robots right D. To the robots left - CORRECT ANSWER C What key is depressed to switch between the different jog modes? A. POSN B. MENU C. FCTN D. COORD - CORRECT ANSWER D What two buttons display the Jog Menu? A. Shift and Display B. Menu and any job key C. Shift and COORD FANUC HANDLING PRO LATEST UPDATE 2 | P a g e D. Group and COORD - CORRECT ANSWER C What type of memory is saved when performing an image backup? A. F-ROM only B. S-RAM only C. F-ROM and SRAM D. DRAM - CORRECT ANSWER C Singularity error can be corrected by moving? A. Joint 2 (+/-) 10 degrees B. Joint 3(+/-) 15 degrees C. Joint 5 (+/-) 10 degrees D. Joint 6 (+/-) 15 degrees - CORRECT ANSWER C Where is the default Tool Center Point? A. Intersection of J1 and J2 B. Center of faceplate C. Tip of the default tool D. FANUC robots do not use Tool Center Points - CORRECT ANSWER B What type of I/O handles communication between the controller and the robot?