11/05/2024 12:06 PM
BOMA- Plant Operations Exam Questions
With Correct Answers
All of the above: Threaded, Certified welds, Flanges - answer✔How may fittings be attached to a high
pressure boiler?
accumulation test - answer✔Which test determines the relieving capacity of safety valves?
economizer - answer✔Flue gases can leave at high temperatures. We can recover some of this heat
using a(n)?
waste or extracted steam - answer✔Feed water is typically heated with:
boiler capacity - answer✔What is the maximum pounds of steam per hour of a boiler called?
hot well - answer✔What is a steam condensers reservoir called?
Closed, locked, and tagged - answer✔When inspecting a boiler, main steam valves are:
pressure - answer✔Boiler draft is the difference in (blank) between two points:
1 - answer✔Boilers are required to have how many pressure gauges?
open feedwater heater - answer✔Feed water pumps take water from the:
hot feed water - answer✔High vibrations in a feed water pump could be caused by:
centrifugal - answer✔Which type of pump is best for handling dirty water?
piston ring - answer✔Which is not a part of a centrifugal pump?
quick start up - answer✔Why have check valves on multiple feed water pumps?
true - answer✔True or False? Many dynamic displacement pumps can be started with the discharge
valve closed or throttled?
Rotary - answer✔Lubricating oil pumps are typically:
dynamic displacement - answer✔Centrifugal pumps differ from reciprocating in that they are:
, ©THEBRIGHT EXAM SOLUTIONS
11/05/2024 12:06 PM
140 F - answer✔Most codes restrict temperature of water entering the sewer to a max of:
capacity control - answer✔Why do compressors have unloaders?
detergent free oil - answer✔Air compressors require:
hydrostatic test - answer✔What could you do to test an air receiver for leaks?
drum water level - answer✔A three element feedwater regulator measures:
75% - answer✔Safety valves require what percentage of their operating pressure to be lifted by hand?
10' above feedwater pump - answer✔The D.A. tanks are typically:
Inches of H2O - answer✔A draft gauge measures?
orstat analyzer - answer✔Carbon monoxide, carbon dioxide, and oxygen are measured with a(n)?
you get 25psi in the boiler - answer✔When putting a cold boiler back in service, open the vent until:
15 psig - answer✔Low pressure steam boilers have maximum allowable working pressure of:
around the tubes - answer✔In watertube boilers, heat and gases of combustion pass:
a fire tube boiler - answer✔The type of boiler with the largest capacity of energy is:
either: outside the boiler or inside the boiler - answer✔The burner box of a firetub boiler could be:
reduces turbulence in the gauge glass - answer✔On a boiler, the water column:
safety valves - answer✔The fitting which is most critical in stopping a boiler explosion is:
heating surface - answer✔The (blank) has water on one side and gasses of combustion on the other:
temperature setting - answer✔Which will not be found on a safety valves nameplate?
tracer line - answer✔To keep oil liquefied we run this line with our fuel line:
open feed water heater - answer✔Closed feedwater heaters are fed by the:
downcomers - answer✔In a watertube boiler, what tubes feed water to the mud-drum?
all of the above: Open feedwater heaters, Air preheaters, Closed feedwater heaters - answer✔Boiler
efficiency is increased by?
highest part of the steam side - answer✔The boiler vents are installed:
all of the above: Oil is in the water, Superheaters feed a turbine, High pressure boilers feed a turbine -
answer✔Oil separators are needed when: