Sense level 1 welding process certification test module 9: welding inspection and test principles Questions and Answers 100% Verified

the base material next to the weld that is not melted, but that undergoes structural and metallurgical changes is called - ️️the heat affected zone a weld produced by filling an elongated hole in an overlapping member, fusing it to the member beneath is called a - ️️slot weld according to the AWS D1.1 code, if a welder continues to use a particular procedure, how long does his/ her qualification remain - ️️indefinitely, unless the ability of the welder is questioned which of the following is not a type of weld joint - ️️fillet the portion of the joint where the two pieces to be joined come closet together is called the - ️️joint root a weld having a triangular cross section which is applied to a T-joint, corner joint or lap joint is called a - ️️fillet weld a weld used to build up thin surfaces and to provide a layer of corrosion protection and/ or abrasion-resistance is called - ️️surfacing weld the height of a weld above the metal in a groove weld is the - ️️weld reinforcement a __________ fillet weld has the same leg and size dimensions - ️️equal leg a weld formed by progressing along the joint with a side-to-side motion is called - ️️weave bead the problem occurring in weldments due to the non-uniform heating produced by welding is called - ️️distortion the most common type of destructive testing of weld is called - ️️bend test a weld discontinuity caused by the improper termination of the welding arc is referred to as - ️️crater cracka discontinuity that results from the entrapment of gas within the weld is referred to as - ️️porosity which weld metal discontinuity is generally considered to be the most severe - ️️cracks which weld discontinuity results from weld metal flowing out of the joint and laying on the base metal surface without fusing - ️️overlap