NICET Level 2 ITM of Water Based
Systems Exam|156 Complete Questions
and Answers
When placing a LOTO on a system, how many locks should be applied? - -As
many locks as their are personnel working on the system.
-A ladder must be able to support ____ times the weight of the expected load
- -3.3
-It is acceptable to enter into a confined space without an attendant, but
only if all other precautions and PPE are taken. - -False
-A defective air pressure gauge on the supply air of a dry pipe system is
considered a _____ - -Critical deficiency
-When taking a sprinkler system out of service, the following are approved
sources of a temporary water supply
-A hose from a fire hydrant to the FDC
-A portable tank and pump
-A standby fire department pumper - -True
-When using a ladder for electrical work, _______ - -The rails must be non-
conductive.
-When using an aerial lift, you must
-Tie off with a lanyard
-Wear a hard hat
-Have received appropriate training - -True
-When an employee may be exposed to hazardous chemicals, when must
training be given?
-When they might be exposed to said chemical
-When new chemicals have been added to the work place - -True
-Toxic chemicals will be hazardous in a confined space when the ______ is
exceeded - -PEL
-A hydropnuematic pump is used to check for air leaks on a dry pipe system
- -False
, -When shutting down a system for impairment you must hang a tag at
_______ - -System control valve and the FDC
-Prior to entering a confined space, oxygen must be tested to be between
______ - -the minimum and maximum levels
-Before opening a fire pump controller and measuring voltage and amps you
must be trained in _____ - -NFPA 70E, arc flash, and the proper PPE
-When testing a antifreeze solutions, what tools are recommended? - -
Refractometer, or hyrdometer
-The person who performs the LOTO on a piece of equipment to perform
repairs or maintenance is the _______ - -authorized person
-The minimum size of an impairment tag is _____ in. - -4x6
-Safe oxygen levels in a confined space is between _____ and _____ % - -19.5
and 23.5
-The correct angle of a ladder from the base to the wall is ____ degrees - -75
1/2
-Each employee exposed to fall hazards must be trained
-When the employee is assigned to a work area where fall hazards exist
-When there is a new fall hazard
-When the fall protection program is inadequate - -True
-When a fire protection system is out of service for more than ____ hrs at
least one of the following shall be provided
-Evacuation of the building of section affected by the OOS system
-An approved fire watch
-Temporary water supply
-a program to eliminate ignition sources and limit the amount of fuel
available to the fire - -10
-An obstructed sprinkler is not an example of a critical deficiency - -False
-Your safety LOTO lock can be used for other purposes - -False
-Closed valves are the primary cause of failure for water based fire
protection systems - -True
Systems Exam|156 Complete Questions
and Answers
When placing a LOTO on a system, how many locks should be applied? - -As
many locks as their are personnel working on the system.
-A ladder must be able to support ____ times the weight of the expected load
- -3.3
-It is acceptable to enter into a confined space without an attendant, but
only if all other precautions and PPE are taken. - -False
-A defective air pressure gauge on the supply air of a dry pipe system is
considered a _____ - -Critical deficiency
-When taking a sprinkler system out of service, the following are approved
sources of a temporary water supply
-A hose from a fire hydrant to the FDC
-A portable tank and pump
-A standby fire department pumper - -True
-When using a ladder for electrical work, _______ - -The rails must be non-
conductive.
-When using an aerial lift, you must
-Tie off with a lanyard
-Wear a hard hat
-Have received appropriate training - -True
-When an employee may be exposed to hazardous chemicals, when must
training be given?
-When they might be exposed to said chemical
-When new chemicals have been added to the work place - -True
-Toxic chemicals will be hazardous in a confined space when the ______ is
exceeded - -PEL
-A hydropnuematic pump is used to check for air leaks on a dry pipe system
- -False
, -When shutting down a system for impairment you must hang a tag at
_______ - -System control valve and the FDC
-Prior to entering a confined space, oxygen must be tested to be between
______ - -the minimum and maximum levels
-Before opening a fire pump controller and measuring voltage and amps you
must be trained in _____ - -NFPA 70E, arc flash, and the proper PPE
-When testing a antifreeze solutions, what tools are recommended? - -
Refractometer, or hyrdometer
-The person who performs the LOTO on a piece of equipment to perform
repairs or maintenance is the _______ - -authorized person
-The minimum size of an impairment tag is _____ in. - -4x6
-Safe oxygen levels in a confined space is between _____ and _____ % - -19.5
and 23.5
-The correct angle of a ladder from the base to the wall is ____ degrees - -75
1/2
-Each employee exposed to fall hazards must be trained
-When the employee is assigned to a work area where fall hazards exist
-When there is a new fall hazard
-When the fall protection program is inadequate - -True
-When a fire protection system is out of service for more than ____ hrs at
least one of the following shall be provided
-Evacuation of the building of section affected by the OOS system
-An approved fire watch
-Temporary water supply
-a program to eliminate ignition sources and limit the amount of fuel
available to the fire - -10
-An obstructed sprinkler is not an example of a critical deficiency - -False
-Your safety LOTO lock can be used for other purposes - -False
-Closed valves are the primary cause of failure for water based fire
protection systems - -True
