CCNA practice test questions with
100% Accurate answers
What are the steps to configure a static route - -Configure unidirectional
static routes to and from a stub network
Define a path to the IP destination network
-Question: Which of the following commands will display information about
the specific port channel interface? - -show etherchannel port-channel
-show etherchannel port-channel - -Use the [show vlan] command to verify
that the port is in the correct VLAN
Use the [show mac address-table] command to check which addresses were
learned on a particular port and which VLAN that port is assigned
-You are troubleshooting a connectivity issue on the Branch router when you
realize that a ping test to the destination network is not successful. The
Branch and corresponding HQ router have their neighbor adjacency set up.
What could be the problem? - -The HQ router isn't advertising the route
There is a route missing to the destination in the Branch router`s routing
table
-A user is experiencing a loss of end-to-end connectivity in an IPv4 network.
You have verified that there is no physical connectivity issue. Logically, what
should you check next? - -Whether the current path is undesirable
-Which statements describe a trunk operation? - -It's the link between an
Ethernet switch interface and a router
Cisco supports the 802.1 Q trunking protocol
-You are tasked with configuring a switch so that it can be accessed
remotely. What do you need to configure in order to accomplish this? - -An
IP address and subnet mask
A default gateway
-Which of the following LSA types describes the state of router links to the
area and is flooded only within this particular area? - -Type 1
-Which troubleshooting steps are used when a trunk is not established? - -
Use the [show interfaces trunk] command to check if a trunk has been
established between switches
Use the [show interfaces trunk] command to check whether the local and
peer native virtual LANs, or VLANs, match
100% Accurate answers
What are the steps to configure a static route - -Configure unidirectional
static routes to and from a stub network
Define a path to the IP destination network
-Question: Which of the following commands will display information about
the specific port channel interface? - -show etherchannel port-channel
-show etherchannel port-channel - -Use the [show vlan] command to verify
that the port is in the correct VLAN
Use the [show mac address-table] command to check which addresses were
learned on a particular port and which VLAN that port is assigned
-You are troubleshooting a connectivity issue on the Branch router when you
realize that a ping test to the destination network is not successful. The
Branch and corresponding HQ router have their neighbor adjacency set up.
What could be the problem? - -The HQ router isn't advertising the route
There is a route missing to the destination in the Branch router`s routing
table
-A user is experiencing a loss of end-to-end connectivity in an IPv4 network.
You have verified that there is no physical connectivity issue. Logically, what
should you check next? - -Whether the current path is undesirable
-Which statements describe a trunk operation? - -It's the link between an
Ethernet switch interface and a router
Cisco supports the 802.1 Q trunking protocol
-You are tasked with configuring a switch so that it can be accessed
remotely. What do you need to configure in order to accomplish this? - -An
IP address and subnet mask
A default gateway
-Which of the following LSA types describes the state of router links to the
area and is flooded only within this particular area? - -Type 1
-Which troubleshooting steps are used when a trunk is not established? - -
Use the [show interfaces trunk] command to check if a trunk has been
established between switches
Use the [show interfaces trunk] command to check whether the local and
peer native virtual LANs, or VLANs, match
