RYANAIR CONVERSION #3 TEST QUIDE
QUESTIONS WITH CORRECT ANSWERS
1. Which lever is used to slide a pilot seat fully AFT? - Answer-H Lever
3. If the No1 becomes incapacitated before departure, what is the procedure? -
Answer-- No2 becomes No1, if qualified.
- No3 becomes No2.
- No4 remains in position.
4. If the No2 becomes incapacitated during the flight, what is the procedure? - Answer--
No1 remains in position.
- No3 becomes No2.
- No4 remains in position.
5. CC incapacitated Prior to Departure, if there is NOT a positioning, qualified Ryanair
CC available and fit to operate, what is the procedure? - Answer-1. The No3's jumpseat
will remain unoccupied.
2. The No2 will now be alone at the back of the A/C and will be responsible for both, the
L2 door and R2 doors.
3. It will normally be necessary to brief an ABP for the R2 door in routine circumstances,
however in an emergency situation, ABP's shall be selected and briefed as per
procedures outlined in section 4 oaths manual.
4. The assigned No2 shall be responsible for both No2 and No3 duties under normal
and emergency situation.
5. When conducting the safety demonstration with 3 CC the No1 shallowing verbally do
the safety demostration PA. The remaining CC shall conduct the safety demonstration
in rows 1 and 16.
6. If there are only 3 CC on board, boarding cannot commence until refuelling has been
completed. All 3 CC must be ON BOARD AT ALL TIMES when passengers are
boarding, on board or disembarking.
7. CC incapacitation inflight, if there is a positioning qualified Ryanair CC available and
fit to operate, what is the procedure? - Answer-They may sit in the R2 jumpseat,
wearing a hi-viz jacketed, assume the responsibilities of No3, under the direction of No2
(make a PA, re: hi-viz).
8. What is the purpose of the Inertia Reel Lock? - Answer-To prevent the incapacitated
pilot falling into the flight controls.
9. On the pilots seat, where is the H lever located? - Answer-Beside the pilot's seat
inboard.
, 10. What does incapacitation mean? - Answer-This general means that someone is
being deprived of their capacity or natural power, or to be rendered incapable or unfit.
11. What is Pilot Incapacitation Drill? - Answer-1. Remove the pilot from the controls,
ensure airway is open.
2. Ensure seatbelts is fastened and shoulders harness is secure.
3. Cross the pilot arms and secure them behind the shoulders harness.
4. Engage inertial reel lock.
5. Ensure seat back is in the fully upright position (recline lever).
6. Slide seat fully AFT. H lever.
7. Remove pilots feet from rudder pedal, cross the legs behind the joke.
12. After administering FIRST AID to an incapacitated pilot and no other pilot is
available what will CC do? - Answer-Assist the operating pilot.
13. How many Cabin Crew will remove the incapacitated pilot? - Answer-2 Cabin Crew.
14. Pilot incapacitation drill. Why does the Inertial Reel Lock have to be engaged? -
Answer-To prevent the incapacitated pilot falling into the flight controls.
15. Where does each CC sit for take-off and landing? - Answer-No1 - L1 jumpseat
outboard.
No2 - L2 jumpseat inboard.
No3 - R2 jumpseat inboard.
No4 - L1 jumpseat inboard.
16. What do we use to advice engineering of safety related items, equipment which
need correction or repair or any appearance defects? - Answer-Cabin Defects Log
Book.
17. How many double jumpseats onboard? - Answer-3 DOUBLE jumpseats.
18. On which jumpseat and where does No1 seat? - Answer-L1 Jumpseat outboard.
19. On which jumpseat and where does No2 seat? - Answer-L2 Jumpseat inboard.
20. On which jumpseat and where does No3 seat? - Answer-R2 Jumpseat inboard.
21. On which jumpseat and where does No4 seat? - Answer-L1 Jumpseat inboard.
23. If the toilet flush valve fails to reset, what should be done? - Answer-- Close the
toilet lid.
- Pull the manual shut off handle located at the base of the toilet.
QUESTIONS WITH CORRECT ANSWERS
1. Which lever is used to slide a pilot seat fully AFT? - Answer-H Lever
3. If the No1 becomes incapacitated before departure, what is the procedure? -
Answer-- No2 becomes No1, if qualified.
- No3 becomes No2.
- No4 remains in position.
4. If the No2 becomes incapacitated during the flight, what is the procedure? - Answer--
No1 remains in position.
- No3 becomes No2.
- No4 remains in position.
5. CC incapacitated Prior to Departure, if there is NOT a positioning, qualified Ryanair
CC available and fit to operate, what is the procedure? - Answer-1. The No3's jumpseat
will remain unoccupied.
2. The No2 will now be alone at the back of the A/C and will be responsible for both, the
L2 door and R2 doors.
3. It will normally be necessary to brief an ABP for the R2 door in routine circumstances,
however in an emergency situation, ABP's shall be selected and briefed as per
procedures outlined in section 4 oaths manual.
4. The assigned No2 shall be responsible for both No2 and No3 duties under normal
and emergency situation.
5. When conducting the safety demonstration with 3 CC the No1 shallowing verbally do
the safety demostration PA. The remaining CC shall conduct the safety demonstration
in rows 1 and 16.
6. If there are only 3 CC on board, boarding cannot commence until refuelling has been
completed. All 3 CC must be ON BOARD AT ALL TIMES when passengers are
boarding, on board or disembarking.
7. CC incapacitation inflight, if there is a positioning qualified Ryanair CC available and
fit to operate, what is the procedure? - Answer-They may sit in the R2 jumpseat,
wearing a hi-viz jacketed, assume the responsibilities of No3, under the direction of No2
(make a PA, re: hi-viz).
8. What is the purpose of the Inertia Reel Lock? - Answer-To prevent the incapacitated
pilot falling into the flight controls.
9. On the pilots seat, where is the H lever located? - Answer-Beside the pilot's seat
inboard.
, 10. What does incapacitation mean? - Answer-This general means that someone is
being deprived of their capacity or natural power, or to be rendered incapable or unfit.
11. What is Pilot Incapacitation Drill? - Answer-1. Remove the pilot from the controls,
ensure airway is open.
2. Ensure seatbelts is fastened and shoulders harness is secure.
3. Cross the pilot arms and secure them behind the shoulders harness.
4. Engage inertial reel lock.
5. Ensure seat back is in the fully upright position (recline lever).
6. Slide seat fully AFT. H lever.
7. Remove pilots feet from rudder pedal, cross the legs behind the joke.
12. After administering FIRST AID to an incapacitated pilot and no other pilot is
available what will CC do? - Answer-Assist the operating pilot.
13. How many Cabin Crew will remove the incapacitated pilot? - Answer-2 Cabin Crew.
14. Pilot incapacitation drill. Why does the Inertial Reel Lock have to be engaged? -
Answer-To prevent the incapacitated pilot falling into the flight controls.
15. Where does each CC sit for take-off and landing? - Answer-No1 - L1 jumpseat
outboard.
No2 - L2 jumpseat inboard.
No3 - R2 jumpseat inboard.
No4 - L1 jumpseat inboard.
16. What do we use to advice engineering of safety related items, equipment which
need correction or repair or any appearance defects? - Answer-Cabin Defects Log
Book.
17. How many double jumpseats onboard? - Answer-3 DOUBLE jumpseats.
18. On which jumpseat and where does No1 seat? - Answer-L1 Jumpseat outboard.
19. On which jumpseat and where does No2 seat? - Answer-L2 Jumpseat inboard.
20. On which jumpseat and where does No3 seat? - Answer-R2 Jumpseat inboard.
21. On which jumpseat and where does No4 seat? - Answer-L1 Jumpseat inboard.
23. If the toilet flush valve fails to reset, what should be done? - Answer-- Close the
toilet lid.
- Pull the manual shut off handle located at the base of the toilet.
