Nicet Level 1 Fire Alarm Inspection & Testing Questions and Answers |100% Pass

EMILLYCHARLOTTE 2024/2025 ACADEMIC YAER ©2024 EMILLYCHARLOTTE. ALL RIGHTS RESERVED FIRST PUBLISH SEPTEMBER 2024 Page 1/4 Nicet Level 1 Fire Alarm Inspection & Testing Questions and Answers |100% Pass Verification of performance of inspection and testing programs shall do which of the following to - Answer-Verify that the installed system meets the operation requirements of the version of code when the system was installed, verify the correct operation of the system. Which of the following shall be done when conducting tests in lead-acid type batteries - Answer- Annually conduct a discharge test with the charger disconnected while conducting a load test with full alarm load or an artificial load, Area of refuge two-way communication systems are required to be tested in which of the following three ways - Answer-Verify Receipt of visual and audible signal at the transmitting and receiving unit, respectively How often shall secondary power supply be tested? - Answer-Annually How often are video image smoke and fire detectors required to be inspected? - Answer-Annually Which two of the following are true regarding acceptable test plans? - Answer-Shall be documented with the testing records, shall be written to clearly establish the scope of the testing for the fire alarm or signaling system. How often shall fire optic cable connections be inspected? - Answer-Annually EMILLYCHARLOTTE 2024/2025 ACADEMIC YAER ©2024 EMILLYCHARLOTTE. ALL RIGHTS RESERVED FIRST PUBLISH SEPTEMBER 2024 Page 2/4 How many years after the initial installation shall all fixed temperature non restorable line type detectors be replaced or have 2 per 100 laboratory tested? - Answer-20 Years How often are digital alarm communicator transmitters required to be inspected? - Answer-Annually How are rate of rise heat detectors tested? - Answer-Heat gun or something similar What must be done when using a multimeter to measure current? - Answer-Put the meter in series with the circuit (Pulling negative wire and replacing it with voltmeter to read current) In a visual inspection of a fire alarm system how often should in building fire emergency voice/alarm communications equipment be inspected? - Answer-Semi-Annually How often are fire alarm devices to be cleaned? - Answer-Annually All supervising station alarm systems transmission equipment shall report initiating device activation within how long? - Answer-90 Seconds What shall be done when testing basic interfaces? - Answer-Verify Signals required to be transmitted are received at the control unit Which two of the following ways shall audible a