OSHA 10 Final Exam Questions and Answers 2024

OSHA 10 Final Exam Questions and Answers 2024 The creation of OSHA provided this important right to workers: The right to a safe and healthful workplace. What type of OSHA inspection is conducted when immediate death or serious harm is likely? Imminent danger. OSHA requires that employers pay for most required personal protective equipment (PPE), including: Hard hats. During an OSHA inspection: You have the right to talk to the inspector privately. When an employer receives an OSHA citation, it must be: Posted for 3 days or until the violation is fixed. The right of workers to seek safety and health on the job without fear of punishment is spelled out in: Section 11(c) of the OSH Act. Among the rights related to OSHA recordkeeping, workers have the right to review: The OSHA 300 Log and the OSHA 300 Summary. OSHA's mission is to: Protect the safety and health of America's workers. One of the main responsibilities employers have under OSHA is to: Provide training required by OSHA standards. A Material Safety Data Sheet (MSDS) gives in formation about: Hazardous chemicals. If you feel that an OSHA inspection is needed to get hazards corrected at your workplace, which is your best option? Submit a written, signed complaint with specific hazard information. The OSHA standards for Construction and General Industry are also known as: Part 1926 and Part 1910. When working over dangerous equipment and machinery, fall protection must be provided ___________. regardless of distance Falls, struck-by object, caught-in or between, and electrocution are referred to by OSHA as ___________. "Focus Four" Hazards Webbing used for lifeline, lanyard and harness ropes and straps must be made of ________ fibers. synthetic What are the ways employers can protect workers from falls? Guardrails, safety net systems and personal fall arrest systems. For workers on scaffolds, fall protection must be provided if they are working ______ above a lower level. 10 feet Personal fall arrest systems must be inspected for damage __________ each use. before In construction, falls to a lower level are a major cause of fatalities. True In general, fall protection must be provided to construction workers who are working on surfaces with unprotected sides and edges which are ______ above the lower level. 6 feet Overreaching is a factor that contributes to fall or fatalities involving ladder usage. True Guardrails are often used by employers to protect workers from falls. How high must the top guardrail (the toprail) be above the working surface? 42 inches, plus or minus 3 inches More ___________ are killed from falls than in any other construction occupation. Ironworkers Competent persons are not necessary when scaffolds are being moved. False Not every walking or working surface can be a potential fall hazard. False A personal fall arrest system consists of: An anchorage, lanyard and connectors, and a full body harness. Employees may file a complaint with OSHA if unsafe working conditions are not corrected. True The top of a ladder must extend at least ______ above the surface you are climbing onto. 3 feet Safety nets must absorb the force of a 400-pound bag of sand dropping onto the net. This is referred to as a "__________". drop test Employers are required to keep worksites free from: All of the above ([a] Scrap lumber with protruding nails, [b] Waste and trash, [c] Combustible liquids.) Scaffold accidents are usually attributed to factors like the planking or support giving way, or to a lack of guardrails or fall protection. True Employers need to have rescue procedures in place in the event of a fall. True Wet or damp conditions worsen electrocution hazards. True Which of the following are preventative measures that can be taken to protect yourself from electrocution hazards? A and C only ([a] Keep a safe distance from overhead power lines, [c] Use nonconductive equipment) Which of the following are ways employers must protect their employees on the job site? All of the above ([a] Ensure overhead power line safety, [b] By supplying GFCIs, or ground-fault circuit interrupters, [c] Establish and enact an assured equipment grounding conductor program [AEGCP]) Which of the following items contributed to the electrocution in the previous case study? All of the above ([a] Use of known faulty equipment, [b] lack of grounding, [c] Short in a receptacle) It's okay to use extension cords with worn insulation, as long as you are careful about it. False Employers are NOT required to enforce lockout/tagout safety-related work practices on the job site. False Which of the following is NOT a category of electrical burns? Shock Electrocution was the second leading cause of worker deaths on construction sites in the United States in 2011. True Which of the following are a part of PPE that can prevent electrocution? All of the above ([a] Rubber insulating gloves, [b] hoods, [c] sleeves) In the previous case study, what measures could have been taken to prevent the accident from occurring? Both of the above could have prevented the accident from occurring ([a] Workers should have been aware of overhead power lines, [b] employees should have received proper safety training) If your hard hat sustains a heavy blow from a falling or flying object you ___________________. must replace it immediately To safely control the traffic flow and protect workers near public roadways and moving construction equipment use you could use? All of the above ([a] Traffic signs, [b] barricades, [c] flaggers) All rigging equipment must be inspected _________ each lift. prior to