AUTOMOTIVE TECHNOLOGY ASE TEST
QUESTIONS AND ANSWERS WITH
SOLUTIONS 2024
Technician A only - ANSWER Tire pressure on a passenger vehicle is being checked and adjusted at
ambient temperature
technician A says that correct tire inflation pressure for the vehicle may be found on a placard on the
driver's door
technician B says that correct tire inflation pressure for the vehicle may be found on the markings on the
tire sidewall.
a. voltage regulator - ANSWER a vehicle's battery prematurely fails. A charging system output test shows
the generator (alternator) is producing a constant 16.0 volts. this could indicate a failed
a. anaerobic - ANSWER which of these sealers cures in the absence of air?
a. a only - ANSWER technician A says that, when reinstalling a wheel and tire assembly on a vehicle, the
lug nuts should be tightened using a torque wrench.
technician B says that, when reinstalling a wheel and tire assembly on a vehicle, the lug nuts should be
tightened in a circular pattern
d. air in the cooling system - ANSWER After a coolant thermostat replacement, the engine overheats. this
could be caused by:
a. a failed brake booster - ANSWER The following question contains the word EXCEPT. Read the question
carefully and look for the choice that could not cause the described situation.
A grabbing brake condition can be caused by any of these EXCEPT:
QUESTIONS AND ANSWERS WITH
SOLUTIONS 2024
Technician A only - ANSWER Tire pressure on a passenger vehicle is being checked and adjusted at
ambient temperature
technician A says that correct tire inflation pressure for the vehicle may be found on a placard on the
driver's door
technician B says that correct tire inflation pressure for the vehicle may be found on the markings on the
tire sidewall.
a. voltage regulator - ANSWER a vehicle's battery prematurely fails. A charging system output test shows
the generator (alternator) is producing a constant 16.0 volts. this could indicate a failed
a. anaerobic - ANSWER which of these sealers cures in the absence of air?
a. a only - ANSWER technician A says that, when reinstalling a wheel and tire assembly on a vehicle, the
lug nuts should be tightened using a torque wrench.
technician B says that, when reinstalling a wheel and tire assembly on a vehicle, the lug nuts should be
tightened in a circular pattern
d. air in the cooling system - ANSWER After a coolant thermostat replacement, the engine overheats. this
could be caused by:
a. a failed brake booster - ANSWER The following question contains the word EXCEPT. Read the question
carefully and look for the choice that could not cause the described situation.
A grabbing brake condition can be caused by any of these EXCEPT:
