AUTOCAD CHAPTER 8; Questions & Answers
100% Pass
Which of the following commands places marks on an object at equally spaced locations based
on the number of segments specified? CORRECT ANSWER-Divide
A surface that is at an angle to the line of sight, and therefore appears shorter than its true size
and shape, is said to be ______________________________. CORRECT ANSWER-
foreshortened
When you use the DIVIDE command, you specify the spacing between increments.
CORRECT ANSWER-F
The top view is the most important view in a multiview drawing. CORRECT ANSWER-F
The views of a multiview drawing are created through ______________________________
projection. CORRECT ANSWER-orthographic
In a view created using orthographic projection, the line of sight is perpendicular to the object.
CORRECT ANSWER-T
How many views are needed to show an object from all (orthographic) sides? CORRECT
ANSWER-6
, AUTOCAD CHAPTER 8; Questions & Answers
100% Pass
A previously drawn symbol or shape that can be inserted instead of point objects when a line is
divided or measured is a(n) ____. CORRECT ANSWER-Block
Point size can be set relative to screen magnification. CORRECT ANSWER-T
Which of the following is not a reason to select a certain view of an object as the front view?
CORRECT ANSWER-most hidden lines
AutoCAD's two types of construction lines are ____. CORRECT ANSWER-xlines and rays
An auxiliary view in which only the inclined surface is shown is known as a(n)
______________________________ auxiliary view. CORRECT ANSWER-partial
The first point you pick when you specify an xline is the ______________________________
point. CORRECT ANSWER-Root
When you use the MEASURE command, you specify the number of increments and the length
of each increment. CORRECT ANSWER-F
To create a point to mark a location in the drawing, you can use the
______________________________ command. CORRECT ANSWER-Point
100% Pass
Which of the following commands places marks on an object at equally spaced locations based
on the number of segments specified? CORRECT ANSWER-Divide
A surface that is at an angle to the line of sight, and therefore appears shorter than its true size
and shape, is said to be ______________________________. CORRECT ANSWER-
foreshortened
When you use the DIVIDE command, you specify the spacing between increments.
CORRECT ANSWER-F
The top view is the most important view in a multiview drawing. CORRECT ANSWER-F
The views of a multiview drawing are created through ______________________________
projection. CORRECT ANSWER-orthographic
In a view created using orthographic projection, the line of sight is perpendicular to the object.
CORRECT ANSWER-T
How many views are needed to show an object from all (orthographic) sides? CORRECT
ANSWER-6
, AUTOCAD CHAPTER 8; Questions & Answers
100% Pass
A previously drawn symbol or shape that can be inserted instead of point objects when a line is
divided or measured is a(n) ____. CORRECT ANSWER-Block
Point size can be set relative to screen magnification. CORRECT ANSWER-T
Which of the following is not a reason to select a certain view of an object as the front view?
CORRECT ANSWER-most hidden lines
AutoCAD's two types of construction lines are ____. CORRECT ANSWER-xlines and rays
An auxiliary view in which only the inclined surface is shown is known as a(n)
______________________________ auxiliary view. CORRECT ANSWER-partial
The first point you pick when you specify an xline is the ______________________________
point. CORRECT ANSWER-Root
When you use the MEASURE command, you specify the number of increments and the length
of each increment. CORRECT ANSWER-F
To create a point to mark a location in the drawing, you can use the
______________________________ command. CORRECT ANSWER-Point
