Auto Cad Final Exam Questions and Answers Already Passed

Auto Cad Final Exam Questions and Answers Already Passed From which reference point does AutoCAD begin to measure angles? The measurement of angles in AutoCAD starts from the 3 o'clock position. What does the acronym WCS represent in AutoCAD terminology? WCS stands for World Coordinate System. In 2D drafting within AutoCAD, which axis is typically not utilized? The Z-axis is not used when drawing in 2D. Is there an equivalence between 300 degrees and -60 degrees in AutoCAD? Yes, 300 degrees and -60 degrees represent the same angle. Which of the following methods is not used to input coordinates in AutoCAD? Approximate entry is not a method for inputting coordinates. 2 Which key combination will not initiate the Print command in AutoCAD? Pressing Alt+P does not start the Print command. What is an essential aspect to focus on while learning AutoCAD? Attention should be given to understanding and using the Command Line. For what type of drawing are Polar coordinates primarily used? Polar coordinates are predominantly used for drawing angled lines. What keystrokes are used to undo the most recent command? Control+Z will undo the last command executed. When using the TRIM command, which element should you select first? You should select the cutting edge first when using the TRIM command. How many snap points are associated with an object in AutoCAD? The number of snap points depends on the type of object. 3 What is the minimum number of points needed to define a rectangle in AutoCAD? You need two points to define a rectangle. How many AutoCAD objects are created when drawing a rectangle? A rectangle is considered one AutoCAD object. If a line is drawn at 270 degrees, which direction will it point? A line drawn at 270 degrees will point downward. What is the length of a line from the coordinates (1,4) to (4,4)? The length of the line is 3 units. How long will a line from the coordinates (1,4) to @4<5 be? The line length will be four units.