Maryland State Inspection-technical final Exam Study with correct Question and Answers 2024

Maryland State Inspection-technical final Exam Study with correct Question and Answers 2024 hydraulic system test brake pedal height shall remain constant for one minute pedal reserve test fail for less than 1/3 of total pedal reserve remains inspect brake drums 0.090 inch greater than original diameter substantial cracks on friction surface external cracks extending to the leading edge brake pads wear limit 2/32 inch bonded brake linings wear limit 2/32 inch riveted brake linings wear limit 1/32 of an inch above rivet head vacuum booster test stop engine pump brake pedal several times to deplete vacuum depress pedal with slight force while starting engine pedal should move slightly when engine starts Parking brake test should hold vehicle to the limit of traction at 20% grade in either direction Exhaust System Defects fail for damage and corrosion do not fail for missing resonator if muffler is present exhaust system should exit at approx 45 degree angle to prevent backpressure Exhaust System should extend beyond occupant compartment and enclosed cargo area if it open to occupant compartment to at least the front of the rear wheels and beyond the rear of the rear most door opening. should exceed beyond the side or rear of the body bumper height no higher than 20 inches for passenger vehicles no higher than 28 inches for Class E and Class M Fenders Rear of all fenders should extend downward to the center of the wheel Front of fender should extend forward from vertical centerline to at least within 45 degrees angle of horizontal centerline Should not be extended downward to compensate for suspension mods Headlamps mounted between 24 and 54 inches Mirrors should have ability to hold adjustment unobstructed view 200 feet to the rear securely mounted Vehicle glazing inspect for proper markings inspect for unauthorized materials or conditions that obscure drivers vision AS-1 Glazing is used on the windshield and anywhere on the vehicle AS-2 Glazing may be used anywhere on the vehicle except windshield driver side window Should be able to open and close readily Post manufacture window tint prohibitions tint with one-way mirror effect tint that is red yellow or amber in color Tint that is below 35% light transmittance on passenger cars convertibles and light trucks tint below windshield AS-1 line or 5 inches from top of windshield. tint in front of high mount stop light Window tint on vans light trucks and multipurpose vehicles Windows to the rear of driver may be tinted to any degree of darkness Windshield Acute area Area 8 inches by 5 inches directly in front of driver centered vertically on steering wheel horizontally in centre of critical area Critical area normal windshield wiper sweep except area obscured by hood fenders or rear view mirror Non-Critical area all windshield area outside of critical are