ASE A1 - Practice Test (Section C) Questions And Answers

ASE A1 - Practice Test (Section C) Questions And Answers 2. which of the following steps is the tech LEAST LIKELY to take when pressing the wrist pin into the piston and connecting rod -align the bores in the piston and connecting rod -heat the small end of the rod -make sure that position marks on the piston and connecting rod are oriented properly -heat the wrist pin - ANS-heat the wrist pin (heating the wrist pin is the LEAST LIKELY step because it will cause the pin to expand and prevent it from fitting into the connecting rod and piston bores) -the bores in the piston and the rod should be aligned before pressing in the wrist pin -the small end of the rod should be heated before pressing in the wrist pin -position marks on the piston and rod should be oriented properly before pressing in the wrist pin 3. tech A says a special puller and installer tool is required to remove and install the vibration damper. tech B says if the inertia ring on the vibration damper is loose, the damper must be replaced A B Both Neither - ANS-Both A special puller and installer tool are required to remove and install the vibration damper. Using a regular gear puller to remove the vibration damper will damage the damper. Also, a loose inertia ring on the damper requires replacement of the damper. 5. if new rings are installed without removing the ring ridge, what may be the result?....