API 653 Data Sheets Exam Questions and Answers 100% Pass

API 653 Data Sheets Exam Questions and Answers 100% Pass Fitness For Service - Correct Answer ️️ -API 579 Low Pressure Storage Tanks - Correct Answer ️️ -API 620 Risked Based Inspection - Correct Answer ️️ -API 580 Cathodic Protection - Correct Answer ️️ -API 651 Tank Bottom Linings - Correct Answer ️️ -API 652 Welding on in service equipment containing flammables - Correct Answer ️️ -API 2201 NDE Procedure Guidlines - Correct Answer ️️ -ASME Section V Acceptance Standards for RT of welds - Correct Answer ️️ -ASME Section 8, Div. 1 Alternative evaluation for pits and LTA's - Correct Answer ️️ -ASME Section 8, Div. 2 Welder Qualification - Correct Answer ️️ -ASME Section IX Weld Procedure Qualification - Correct Answer ️️ -ASME Section IX Impact testing method and equipment requirements - Correct Answer ️️ -ASTM A370 Requirement for new welding electrodes - Correct Answer ️️ -AWS NDE personnel qualification (RT and UT flaw detection) - Correct Answer ️️ -ASNT SNT-TC-1A API 650 Appendix for frangible roofs - Correct Answer ️️ -Appendix F API 650 Appendix for hot tanks - Correct Answer ️️ -Appendix M Maximum allowed vertical length of pits on a tank shell - Correct Answer ️️ -2" in 8" Line Max allowed length of pits in the critical zone that can be repaired by weld build up - Correct Answer ️️ -2" in 8" arc Radial length of critical zone measured from shell - Correct Answer ️️ -3" Bottoms- suggested pad thickness - Correct Answer ️️ -3-4" Minimum distance between clusters of surface porosity - Correct Answer ️️ -4" Minimum dimension of shell lap-patch - Correct Answer ️️ -4" Minimum radius of shell flush-patch - Correct Answer ️️ -6" When calculating tmin for shell LTA, minimum distance away from a rivet where "E" is always 1.0 - Correct Answer ️️ -6" Minimum size of a bottom lap-patch that does NOT cross a bottom seam - Correct Answer ️️ -6" Minimum distance between a bottom lap patch and the shell for patches that d