Module 26107-20 Exam Hand Bending
1. The distance from the center point to the edge of a circle is known as the - answer radius
2. Which of the following eliminates wrinkling or flattening when bending PVC? - answer
Plug set
3. A circle with a radius of 15" has a circumference of - answer 94.2
4. Circumference can be calculated using the formula - answer Pi x D
5. Gain is best described as the - answer Distance saved by the arc of 90 bend
6. The distance around a circle is known as the - answer Circumference
7. When creating an offset using 30° bends (with a multiplier of 2.0) to cross a 6-inch obstruction, the distance between bends is - answer 12 inches
8. Two junction boxes are each located on different walls, 18" from the same corner. Given a 90° bend with a take-up of 6" and a gain of 4", what is the developed length of the conduit between them? - answer 32 inches
9. Which of the following should be used to cut EMT? - answer Hacksaw
10. RMC, IMC, and EMT are available in standard lengths of - answer 10 ft
11. The first step in reaming conduit is to - answer Secure the conduit pipe in a vise
12. Which of the following is most commonly used to cut RMC and IMC? - answer Pipe cutter
13. A pocket knife can be used to deburr - answer PVC
14. Forming PVC in the field requires the use of a(n) - answer Hot box
15. A die is used to - answer Cut threads into conduit
1. The distance from the center point to the edge of a circle is known as the - answer radius
2. Which of the following eliminates wrinkling or flattening when bending PVC? - answer
Plug set
3. A circle with a radius of 15" has a circumference of - answer 94.2
4. Circumference can be calculated using the formula - answer Pi x D
5. Gain is best described as the - answer Distance saved by the arc of 90 bend
6. The distance around a circle is known as the - answer Circumference
7. When creating an offset using 30° bends (with a multiplier of 2.0) to cross a 6-inch obstruction, the distance between bends is - answer 12 inches
8. Two junction boxes are each located on different walls, 18" from the same corner. Given a 90° bend with a take-up of 6" and a gain of 4", what is the developed length of the conduit between them? - answer 32 inches
9. Which of the following should be used to cut EMT? - answer Hacksaw
10. RMC, IMC, and EMT are available in standard lengths of - answer 10 ft
11. The first step in reaming conduit is to - answer Secure the conduit pipe in a vise
12. Which of the following is most commonly used to cut RMC and IMC? - answer Pipe cutter
13. A pocket knife can be used to deburr - answer PVC
14. Forming PVC in the field requires the use of a(n) - answer Hot box
15. A die is used to - answer Cut threads into conduit
