FANUC EXAM LATEST UPDATE

FANUC EXAM LATEST UPDATE To display the contents of a Device, you must Generate a Directory. - ANSWER True Teach Pendant programs can be loaded from the FILE menu and one other menu. What is the other screen? - ANSWER Select menu If you are saving files to a disk, you must set the default device. Which of the following menu items would you find this? - ANSWER FILE/UTILITIES You must turn the Teach Pendant ON in order to copy an existing program. - ANSWER false When you enable the AT HOME check within the setup menu, the controller will check to see if the robot is at the home position and if it's not at home position then it will not run the production program. - ANSWER true When the controller is in local mode it cannot start from an external signal such as a PLC or cell controller. - ANSWER true Each production check provides different enabled choices within the program select detail. Which condition takes priority when multiple conditions are enabled? - ANSWER "force conditio n" Can you always start the same program from the SOP cycle start while in remote mode? - ANSWER no What start up method is used when turning on power to the robot and controller without entering boot monitor functions? - ANSWER hot start When assigning user key SU[3}, the key that executes the macro is: - ANSWER shift+move menu When assigning a number for the standard operator user key 1 for controllers R-J3iB and earlier, you can use SP[4]. - ANSWER true A macro that contains a motion instruction can be assigned to user 1 button on the standard operator's panel when using R-J3iB and earlier controllers. - ANSWER true A macro that contains a motion instruction can be assigned to teach pendant user key 1 without the shift key. - ANSWER false The replace option will help you to modify registers, motion speed and termination, inputs and outputs, jump labels, calls and time before and time after. - ANSWER true will add lines in reverse order and renumbers the copied positions with the next available position numbers - ANSWER F4 -- R-POS will add lines in reverse order and retains their original position numbers - ANSWER F2 -- R-POS- ID this is exactly like the RM-POD-ID except that new position numbers are assigned in the pasted lines - ANSWER F5 -- RM-POS will add lines in reverse ore and does not record the positions, but leaves the position numbers blank - ANSWER F1 -- R-LOGIC speed and termination types are pasted in the proper instructions to maintain the original speed and termination of each path segment - ANSWER F3 -- RM-POS- ID will add lines exactly as they were copied and renumbers the copied positions with the next available position number - ANSWER F4 - POSITION will add the lines exactly as they were copied, but leaves the position numbers blank - ANSWER F2 - LOGIC will add lines exactly as they were copied and retains the current position numbers - ANSWER F3 - POS ID The renumber function reassigns all position numbers in the program so that they are in sequential order. Renumbering changes the