Neiep 830 Questions & Answers Already Graded A+

Although typically horizontal in design, the maximum angle of inclination for the moving walk is ______ degrees - Answer-12 A ________ Volt , ______ amp outlet is required by asme for both the upper and lower truss - Answer- 115,15 True or False Water run off must be seperated before the discharge into the public drains - Answer-True For drive motors that require overspeed protection, it must stop the systems if speed exceeds ______ % of rated speed - Answer-20 The nameplate on the brake must indicate the ________ setting - Answer-Torque The _______ brake is similar to the brake system found on gearless traction elevators - Answer-Drum The drive end of a belted walkway is called the _______ ________ - Answer-Head end The tensioning device on the tail end of the belted moving walk is normally set at ______ lbs - Answer- 3000 The portion of the track system that guides the pallets around the turns are called the ______ tracks - Answer-Crab/circle True or false The lip track is used to restrain the step chain roller from up and down movement - AnswerFalse The moving walkway treadway must be at least ______ inches wide - Answer-22 true or false Belted treadways must be vulcanized to provide a continuous loop - Answer-TruePalletized chain systems are either ______ or ______ - Answer-Axled and non axled The solid balustrade requires the use of an upper/lower _______ ________ - Answer-newel wheels The glass panels are usually (1/8",1/4",1/2") thick - Answer-1/2" The _______ handrail is most commonly found on the solid balustrade system - Answer-V-groove Belted treadway moving walks are ( skirted/unskirted ) - Answer-Unskirted True or false The starting switches are two position on/off , and the key can only be removed in the off - Answer-False If the tension carriage shifts too far in either direction the ( broken treadway switch /broken drive chain switch ) will open to stop the drive machine - Answer-Broken treadway switch According to asme the pallet level device will open if it detects a downwared displaced of (1/8",1/4",1/2") - Answer-1/8" On belted walkways, the ______ _______ switch will detect a side to side displacement greater than 3/8". - Answer-Belt alignment On the print, ______ volt power is supplied from step-up transformer taps V1 and VG - Answer-120 The safe relay will (energize /de-energize ) if the run timer relay (rnt) energizes before the handrail speed relay (HSR energizes - Answer-de-energize