BUILDING UTILITIES SYSTEM EXAM QUESTIONS AND ANSWERS 2024

BUILDING UTILITIES SYSTEM EXAM QUESTIONS AND ANSWERS 2024 Apply basic engineering principles and technologies for plumbing systems in building design. a. Construction Details and Constructability b. Building Systems and their Integration c. Building Design d. Implications of Design Decisions e. All of the above -Answer-c. Building Design Analyze and evaluate the implications of plumbing system design decisions in relation to project goals, cost, schedule and quantity. a. Building Design b. Implications of Design Decisions c. Building Systems and their Integration d. Construction Details and Constructability e. All of the above -Answer-b. Implications of Design Decisions Evaluate and determine plumbing system parameters most appropriate for building design. a. Building Systems and their Integration b. Construction Details and Constructability c. Building Design d. Implications of Design Decisions e. All of the above -Answer-a. Building Systems and their Integration Utilize plumbing system details and recognize their effect on constructability, aesthetics, and technical properties. a. Building Design b. Implications of Design Decisions c. Building Systems and their Integration d. Construction Details and Constructability e. All of the above -Answer-d. Construction Details and Constructability Emergency lighting in means-of-egress areas must have an intensity of no less than ____ fc a. 1 fc b. 2 fc c. 5 fc d. 10 fc e. none of the above -Answer-a. 1 fc Which of the following building types would have the most stringent requirements for fire alarm and fire suppression systems? a. motel b. nursing home c. office building d. print shop e. all of the above -Answer-b. nursing home Which of the following is the most important concern in relation to a private water supply? a. fixture pressure b. hardness c. friction loss d. yield e. none -Answer-b. hardness Two adjacent rooms, A and B, are separated by an acoustical partition; there is a noise producing source in room B; the noise reduction in room A is dependent on all of the following EXCEPT the: a. area of the partition b. thickness of the partition c. transmission loss of the partition d. absorption of surfaces in room A e. none of the above -Answer-b. thickness of the partition What is the single number often used to evaluate the acoustic qualities of partitions? a. noise reduction coefficient (NRC) b. sound absorption coefficient c. noise isolation class (NIC) d. sound transmission class (STC) e. A and D -Answer-d. sound transmission class (STC) Which of the following is a requirement of electrical receptacles to be installed in a residential bathroom? a. Locate adjacent to the light switch b. Install below the level of toilet or lavatory fixtures c. Include ground-fault circuit interrupter protection d. Locate a minimum of 6 ft from a tub or shower e. none of the above -Answer-c. Include ground-fault circuit interrupter protection Which of the following can be used most effectively to limit low-frequency sounds in an HVAC system? a. Turning vanes b. Duct lining c. Mufflers d. Dampers e. none of the above -Answer-b. Duct lining Which of the following (4) plumbing fixture